Incoherent Diffraction Imaging with a Pseudo-Thermal Light Source

summary

The gist

Incoherent Diffraction Imaging (IDI) is a diffraction-based imaging technique that exploits second-order spatial correlations of partially coherent light to retrieve structural information from…

In short

The study proposes a table-top Pseudo-Thermal Light Source (PTLS) to experimentally explore Incoherent Diffraction Imaging (IDI) under various conditions and benchmark numerical models. It demonstrates that this setup can measure second-order spatial correlations, achieving good agreement with existing theoretical methods for nanometer-scale diffraction imaging using partially coherent light.

Key concepts

Incoherent Diffraction Imaging (IDI)
A technique that uses the second-order spatial correlations of partially coherent light to reconstruct structural information from scattering centers. It relies on recording diffracted light within a specific timescale relative to the light's coherence time, often applied to incoherent sources like fluorescence.
Pseudo-Thermal Light Source (PTLS)
A table-top optical setup built with a ground-glass diffuser illuminated by a 660 nm diode laser. This source allows control over spatial coherence by adjusting the illumination area and temporal coherence via diffuser rotation speed, enabling exploration of different physical conditions.
Second-order Spatial Correlations (g(2)(q) maps)
These are measurements used to extract structural data about the distribution of scatterers. The normalized g(2)(q) maps show diffraction patterns associated with object intensity distributions, which are then compared against numerical simulations to validate the imaging process.

Terminology used across episodes

This episode discusses

The paper

Incoherent Diffraction Imaging with a Pseudo-Thermal Light Source · Read on arXiv

PABLO SAN MIGUEL CLAVERIA, –SEBASTIÃOŗ⺔NTE ANTUNES, –PEER BIESTERFELD, –MATILDE FERNANDES, –MATILDE GARCIA, –MATILDE NUNES, –LUCAS ANSIA FERNANDEZ, –GARETH O. WILLIAMS, –SVEN FROEHLICH, –DAVID THEIDEL, –PHILIP MOSEL, IHSAN FSAIFES, ANDREA TRABATTONI, MARCO PICCARDO, –JEAN-CHRISTOPHE CHANTELOUP, –MILUTIN KOVACEV, –HAMED MERDJI, AND MARTA FAJARDO

GoLP/Instituto de Plasmas e Fusóo Nuclear, Instituto Superior Técnico, Universidade de Lisboa · Institut für Quantenoptik, Leibniz University Hannover · Laboratoire d’Optique Appliquພ, ENSTA Paris, CNRS, Ecole Polytechnique, Institut Polytechnique de Paris · LULI, CNRS, Ecole Polytechnique, CEA

Incoherent Diffraction Imaging - IDI - is a diffraction-based imaging technique that has been recently proposed to exploit the partial coherence of incoherently scattered light to retrieve structural information from the scattering centers. Similar to the stellar intensity interferometry of Hanbury Brown and Twiss, the signal builds up on the second-order spatial correlations of the emitted light. The complex spatial distribution of the target is thereby encoded in the spatial intensity fluctuations of the scattered light. The first experimental realisations of this imaging technique have been realised using the fluorescence excited by an ultra-short X-ray pulse at Free Electron Laser (FEL) facilities. Here, we propose an alternative set-up based on a table-top Pseudo-Thermal Light Source. This set-up allows us to explore IDI under a wide range of physically relevant conditions as well as to benchmark numerical and analytical models currently used to determine the imaging capabilities of this technique.

DOI: 10.1088/1367-2630/aeb3a4

Transcript

Introduction to the show: ident: Physics. The day in general physics: instruments, methods and results across the field.

Kai: We're looking at the paper: "Incoherent Diffraction Imaging with a Pseudo-Thermal Light Source".

Mira: Here's the gist of the paper. Incoherent Diffraction Imaging (IDI) is a diffraction-based imaging technique that exploits second-order spatial correlations of partially coherent light to retrieve structural information from scattering centers The paper proposes an alternative experimental set-up based on a table-top Pseudo-Thermal Light Source (PTLS) to explore IDI under a wide range of physically relevant conditions and benchmark numerical models IDI is named in analogy to Coherent Diffraction Imaging (CDI), highlighting its reliance on a comparatively lower degree of coherence This technique requires the recording of the diffracted light within a timescale shorter or comparable to the coherence time, tauc, of the light field The autocorrelation of the recorded intensity is insensitive to these spatial variations and will thus progressively build-up when averaging over multiple acquisitions A key application of IDI is to retrieve the structural information of an object via incoherent scattering processes, namely fluorescence Fluorescence is typically considered as incoherent light due to the quantum (random) nature of its emission Experimental Set-up and PTLS Characterization The Pseudo-Thermal Light Source (PTLS) is constructed using a ground-glass diffuser illuminated by a CW diode laser of 660 nm to control spatial coherence via the illumination area The second-order temporal coherence can be controlled by the rotation speed of the diffuser, which is inversely proportional to the illumination area The brightness of this PTLS, namely the number of photons per pixel per frame mu, can be controlled via laser power and additional filtering The temporal gating of the incoherent light is carried out via the exposure time of the detector Measuring Structural Information Second-order spatial correlations are used to extract structural information of the scatterers distribution given a finite degree of coherence of a PTLS The normalized g(2) (®q) maps are shown on Fig.

Kai: 2(d,e,f), where the diffraction patterns associated with each object intensity distribution are clearly visible in these second order spatial correlations Numerical simulations of the computed g(2)(®q) maps reproduce well the experimental features The object intensity distributions shown in Fig.

Mira: 2(a,b) were mostly intended to reproduce what was done in the first IDI experiment

16: and the first high-order correlation imaging experiment

19: Assessing Imaging Capabilities The versatility of this PTLS optical set-up allows for benchmarking analytical and numerical models of IDI The study assesses the scalings of the visibility for different source brightness (mu) and number of temporal modes accumulated in each frame An optimal SBR of ≈ 0.7 is found for a large enough brightness (mu ≳ 0.1) and for M ∼ 1 The overall trends observed both in simulations and experimental data are in good agreement with this scaling, both with respect to μ and M This table-top set-up enables the experimental exploration of IDI over an unprecedented range of physically relevant parameters The measured visibility and trends are found to be in reasonably good agreement with existing numerical and analytical methods used to model IDI experiments This set-up can experimentally benchmark the IDI methodology and thus efficiently address the potential of IDI to realize nanometer scale diffraction-based imaging using partially coherent light sources References J.

Kai: Miao, P.

Paper summary: Kai: To recap, this paper introduces Incoherent Diffraction Imaging with a Pseudo-Thermal Light Source, or PTLS, as a way to test IDI with conditions that are physically relevant. They are exploring how second order spatial correlations can retrieve structure from scattering centers using partially coherent light.

Mira: The core thesis is that by using a table-top setup like the PTLS, they can experimentally probe IDI and compare their measurements against analytical and numerical models of this technique.

Lev: The paper describes building this PTLS with a ground-glass diffuser and a laser to control the coherence time via rotation speed, which is inversely proportional to the illumination area.

Kai: They also show how they measure structural information using normalized g sub two maps, which clearly show the diffraction patterns of different object intensity distributions in these correlations <ref:2501.05417#pg1>.

Mira: The authors then focus on assessing how the imaging capabilities scale with source brightness mu and the number of temporal modes accumulated in each frame.

Lev: They found that an optimal signal to background ratio is around zero point seven for a brightness mu greater than zero point one and M equal to one, which matches what they see in their simulations.

Kai: This gives us concrete data on how the imaging performance behaves with respect to the source brightness and the number of temporal modes involved.

Mira: It also points out that these long acquisition times, around five hours for this experiment, are a consequence of low detected photons per pixel per frame mu equal to seven point seven times ten to minus three and a rather long FEL pulse duration of six point two femtoseconds compared to the coherence time of four point zero femtoseconds.

Lev: That comparison between the pulse duration and the coherence time resulted in a beta value of zero point eighteen, which is important for understanding how things scale.

Kai: So they are using this setup not just to get a picture, but to rigorously test the limits of IDI for physically relevant parameters like coherence time and source brightness.

Mira: The paper also points out that long acquisition times mean imaging more complex objects has been difficult so far because of the demand for XFEL access.

Lev: They explicitly state that rigorous tests are needed for IDI performance at these physical parameters to fully understand the technique.

Conclusion: Kai: So, looking at this paper "Incoherent Diffraction Imaging with a Pseudo-Thermal Light Source", the authors have built a table-top setup to experimentally explore IDI across physically relevant conditions.

Mira: They found that their measured visibility and trends align reasonably well with existing numerical and analytical methods used to model IDI experiments.

Lev: This experimental benchmark shows the potential for using this set-up to test IDI methodology and address the potential of it for nanometer scale diffraction-based imaging using partially coherent light sources.

Kai: In simple terms, they’ve shown that their table-top setup can give us good data that supports the theoretical models they use for IDI.

Mira: The implication is that this technique might be a viable path toward achieving nanometer scale imaging by using these kinds of partially coherent light sources in the future.

Lev: It confirms that testing IDI with source brightness and coherence time is a necessary step before we can really expect it to perform on more complex objects.

Kai: So, this work provides a tangible experimental platform for understanding how IDI works in practice right now.

More episodes

← Home