Bright and pure single-photon source in a silicon chip by nanoscale positioning of a color center in a microcavity

summary

The gist

Bright and pure single-photon source in a silicon chip by nanoscale positioning of a color center in a microcavity is presented by fabricating an all-silicon source of near-infrared…

In short

Researchers created a bright and pure single-photon source using silicon chips. They achieved this by precisely positioning a color center (W center) within a silicon-on-insulator microcavity. This method successfully produced near-infrared linearly polarized single photons, marking a significant step toward on-demand sources for quantum applications in silicon photonics.

Key concepts

Color Center (W Center)
These are specific point defects created in the silicon crystal structure. They act as the emitters that produce light when excited. The researchers selectively created single W centers by using nanoholes during implantation to ensure only one emitter exists where desired.
Silicon-on-Insulator (SOI) Microcavity
This is a tiny optical structure made by layering silicon with a thin insulating layer on top. This structure traps and enhances the light emitted by the color center, allowing it to interact strongly with the single photon, improving its quality and brightness.
Purcell Enhancement Factor (F)
This factor measures how much faster an emitter emits light when placed inside a cavity compared to emitting in bulk silicon. A high F value means the emission rate is significantly boosted by the cavity, which helps in generating bright single photons.
Antibunching ($g^{(2)}(0)$)
This metric quantifies how 'single-photon' the light is. A value of $g^{(2)}(0) < 0.5$ indicates that only one photon is likely to be emitted at a time, confirming the source produces high-quality, non-classical single photons.

Terminology used across episodes

This episode discusses

The paper

Bright and pure single-photon source in a silicon chip by nanoscale positioning of a color center in a microcavity · Read on arXiv

Baptiste Lefaucher, *, Yoann Baron, *, Jean-Baptiste Jager, Vincent Calvo, Christian Elsässer, Giuliano Coppola, Frédéric Mazen, * , Sébastien Kerdilès, Félix Cache, Anaís DrĚau, Jean-Michel Gບretard, *

University of Grenoble Alpes · CEA Grenoble INP · Laboratoire Charles Coulomb, University of Montpellier and CNRS

We present an all-silicon source of near-infrared linearly-polarized single photons, fabricated by nanoscale positioning of a color center in a silicon-on-insulator microcavity. The color center consists of a single W center, created at a well-defined position by Si+ ion implantation through a 150 nm-diameter nanohole in a mask. A circular Bragg grating cavity resonant with the W's zero-phonon line at 1217 nm is fabricated at the same location as the nanohole. By Purcell enhancement of zero-phonon emission, we obtain a photon count rate of 1.29 plus or minus 0.01 Mcounts/s at saturation under above-gap continuous-wave excitation with a Debye-Waller factor of 98.6 plus or minus1.4 %. A clean photon antibunching behavior is observed up to pump powers ensuring saturation of the W's emission (g(2)(0)=0.06 plus or minus0.02 at P=9.2P sat), evidencing that the density of additional parasitic fluorescent defects is very low. We also demonstrate the triggered emission of single photons with 93 plus or minus2 % purity under weak pulsed laser excitation. At high pulsed laser power, we reveal a detrimental effect of repumping processes, that could be mitigated using selective pumping schemes in the future. These results represent a major step towards on-demand sources of indistinguishable near-infrared single photons within silicon photonics chips.

DOI: 10.1038/s41467-026-78809-x

Transcript

Introduction to the show: ident: Physics. The day in general physics: instruments, methods and results across the field.

Kai: I'm Kai.

Mira: And I'm Mira, here with Lev.

Kai: We're looking at the paper: "Bright and pure single-photon source in a silicon chip by nanoscale positioning of a color center in a microcavity".

Mira: Here's the gist of the paper. Bright and pure single-photon source in a silicon chip by nanoscale positioning of a color center in a microcavity is presented by fabricating an all-silicon source of near-infrared linearly-polarized single photons through the nanoscale positioning of a color center in a silicon-on-insulator microcavity The results demonstrate that this method represents a major step towards on-demand sources of indistinguishable near-infrared single photons within silicon photonics chips Source Fabrication and Characterization The W centers are created by a well-known combination of Si+ implantation and thermal annealing The implantation is performed through a mask patterned with nanoholes whose size is tuned to locally create single W centers For a nanohole diameter of 150 nm, single W centers are observed with a yield of 40% with low background emission (g 2(0) ≈ 0.1) and average count rate of 3.2 ± 0.8 kcps The CBG cavities are fabricated by electron beam lithography and reactive ion etching at the same location as the nanoholes Cavity Optimization and Coupling Effects The Purcell enhancement factor F, defined as the ratio between the emission rate in the cavity and bulk silicon, is heavily dependent on the position of the emitter A maximum enhancement factor of 13 is obtained at the center of the cavity The collection efficiency for a cavity-coupled W center was also investigated using FDTD, considering the configuration of our measurement setup A collection efficiency of 51% is obtained at the center of the cavity The spectral detuning ∆λ is the difference between the emission wavelength of the dipole and λres = 1218 nm A collection efficiency of 51% is obtained at zero-detuning, and remains above 40% in the

-20 - +10: nm detuning range Emission Properties and Purity The PL intensity at saturation of the W-1 spot is 1.29±0.01 Mcps together A clean antibunching dip is observed without any correction for detectors dark counts or background emission, with g(2)(0) = 0.03 ± 0.01 at P = 2.8Psat These g(2)(0) values are among the best reported values for Si color centers, as shown in Table I The ZPL accounts for ξ = 98.6 ± 1.4% of the PL intensity Performance and Future Directions Under weak pumping condition, the triggered emission of single-photon pulses is demonstrated with 93±2% purity The zero-phonon emission rate is increased by a factor F > 7.2 While point (1) and the issue of blinking have already been discussed, we see that points (2) and (3) can be radically improved by replacing our low-Fp CBG cavity by a high-Fp waveguide-coupled photonic crystal cavity The strategy is compatible with the integration of multiple single-photon sources connected to the same photonic circuit for quantum applications The bright emission of antibunched photons under CW excitation unveils the strong potential of W centers for building a deterministic SPS in SOI In conclusion, we have demonstrated a source of nearinfrared linearly-polarized single photons obtained by nanoscale positioning of a W center in a SOI CBG cavity Si+ implantation through a mask patterned with nanoholes allows for selective creation of single W centers, positioned in the vicinity of the main antinode of the resonant mode The cavity-coupled emitter has a PL intensity at saturation of 1.29±0.01 Mcps together, with a g(2)(0) value inferior to 0.06 under above-gap CW excitation up to P = 9.2Psat, and with a ZPL fraction of 98.6 ± 1.

Paper summary: Kai: So, looking at the title, "Bright and pure single-photon source in a silicon chip by nanoscale positioning of a color center in a microcavity," it really sums up the whole effort here. It’s about achieving brightness and purity in silicon by controlling where you put that W center.

Mira: Exactly. The authors are showing that this specific technique—the nanoscale positioning—is what allows them to get these near-infrared linearly-polarized single photons from silicon, and they achieved a photon count rate of one point twenty-nine plus or minus zero point one megacounts per second at saturation.

Lev: From an engineering standpoint, the implication is that if you can precisely control the emitter's position to get nearunity probability of being within one hundred twenty nanometers of the cavity center, you have a pathway to building deterministic single-photon sources.

Kai: And they also showed that under continuous wave excitation, they got a g squared zero value inferior to zero point six under above-gap continuous wave excitation up to two point eight psat when pumped at nine point two psat.

Mira: That low antibunching measurement is important because it means the source is good enough for single-photon applications, which they've also shown has a zero phonon line fraction of ninety-eight point six plus or minus one point four percent in intensity.

Lev: The limitation they mention is that they are still using this low Purcell factor CBG cavity, and the authors suggest replacing it with a high Purcell factor waveguide-coupled photonic crystal cavity to radically improve points two and three.

Kai: So, the paper proves that this method works for creating these sources, but the next step in making them truly useful for quantum computing is swapping out that current low Purcell factor cavity.

Mira: Right, so it’s a proof of concept with a clear roadmap for improvement towards on-demand sources within silicon photonics chips.

Conclusion: Kai: So, this paper is about making single photons bright and pure in silicon by precisely placing a color center inside a microcavity.

Mira: It’s essentially showing how controlling that exact spot allows you to get high-quality near-infrared photons out of silicon chips on demand.

Lev: From an engineering standpoint, it means we can build these deterministic sources inside the existing silicon photonics infrastructure.

Kai: The authors achieved a saturation power intensity of one point two nine plus or minus zero point zero one megacounts per second, which is pretty good for this setup.

Mira: They also reported a very low antibunching measurement, a g squared zero value of zero point zero three plus or minus zero point one under those above-gap conditions.

Lev: That low number is what we need to actually run error correction on hardware because it means the source is relatively clean when you try to use it.

Kai: The core idea here is using nanoscale positioning to get that emitter exactly where it needs to be for maximum light enhancement in the cavity.

Mira: They also showed a high zero phonon line fraction, ninety-eight point six plus or minus one point four percent of the total light emission.

Lev: But they flagged that their current cavity design has a low Purcell factor, so getting that performance up is the next big challenge for making this practical.

Kai: So, the title promises brightness and purity through this specific spatial control in silicon microcavities.

Mira: It really points toward how carefully we need to engineer these quantum components within the silicon chip environment.

Lev: But with those limitations, it raises a question about what kind of cavity structure actually needs to be used for true scalability.

More episodes

← Home