Turbophoresis of inertial particles in inhomogeneous turbulence generated by oscillating grids

summary

The gist

Turbophoresis in inhomogeneous turbulent flows leads to the formation of large-scale nonuniform particle number density distributions of inertial particles This effect is associated with an effective…

In short

The study investigated how inertial particles move in turbulent air flows generated by oscillating grids. The results showed that these particles accumulate preferentially in areas where the turbulence intensity is lowest, demonstrating a bulk effect of turbophoresis driven by large-scale gradients rather than boundary effects.

Key concepts

Turbophoresis
This is the process where inertial particles are pushed or pulled by gradients in the surrounding fluid's turbulence. In this case, it causes particles to drift toward regions of lower turbulence intensity.
Inhomogeneous Turbulence
This refers to turbulent flows where the intensity (how 'chaotic' or energetic) changes significantly across space. The experiment used oscillating grids to create such a flow with varying levels of turbulence.
Particle Number Density Distribution
This describes how the concentration of inertial particles is spread out throughout the flow area. The researchers found that this distribution shifts, concentrating particles where the turbulence intensity is minimal.
Mean-Square Turbulent Velocity ($u(rms)$)
This metric quantifies the overall turbulent motion in a specific plane (Y Z). It helps measure how energetic and chaotic the fluid movement is at different locations within the experimental chamber.

Terminology used across episodes

This episode discusses

The paper

Turbophoresis of inertial particles in inhomogeneous turbulence generated by oscillating grids · Read on arXiv

The Pearlstone Center for Aeronautical Engineering Studies · Department of Mechanical Engineering, The Ben-Gurion University of the Negev

Turbophoresis in inhomogeneous turbulent flows leads to the formation of large-scale nonuniform particle number density distributions of inertial particles. This effect is associated with an effective drift velocity directed toward regions of lower turbulence intensity. It depends on the Stokes and Reynolds numbers, as well as on the gradient of the turbulence intensity. In the present study, turbophoretic transport is experimentally investigated in air turbulent flows generated by one-grid and two-grid oscillating systems. The flow velocity field is measured using Particle Image Velocimetry, and the particle spatial distribution is obtained by applying image processing techniques. To isolate the effect of particle accumulation due to turbophoresis from that associated with mean fluid flow, the measured particle number density of inertial particles is normalized by the corresponding distribution obtained for noninertial tracer particles under identical flow conditions. The measurements show preferential accumulation of inertial particles in regions of minimum mean-square turbulent velocity, consistent with the expected behavior of turbophoretic transport.

Transcript

Introduction to the show: ident: Physics. The day in general physics: instruments, methods and results across the field.

Kai: We're looking at the paper: "Turbophoresis of inertial particles in inhomogeneous turbulence generated by oscillating grids".

Mira: Here's the gist of the paper. Turbophoresis in inhomogeneous turbulent flows leads to the formation of large-scale nonuniform particle number density distributions of inertial particles This effect is associated with an effective drift velocity directed toward regions of lower turbulence intensity It depends on the Stokes and Reynolds numbers, as well as on the gradient of the turbulence intensity In this study, turbophoretic transport is experimentally investigated in air turbulent flows generated by onegrid and two-grid oscillating systems The measurements show preferential accumulation of inertial particles in regions of minimum mean-square turbulent velocity.

Kai: Experimental Setup and Measurement The experiments were performed in isothermal inhomogeneous turbulence generated by one and two oscillating grids in air flows The chamber dimensions were Lx = Lz = 26 cm and Ly = 53 cm Each oscillating grid had dimensions of 25 × 25 cm2 and consisted of a square array of bars with a mesh size of 5 cm and a bar width of 1 cm The grids oscillated along the Y direction with frequency f = 10.5 Hz and stroke amplitude Ag = 6 cm The laser light sheet was located in the central vertical Y Z plane at X = 0 The inertial particles used were borosilicate hollow glass particles with an approximately spherical shape.

Mira: Flow Characterization and Turbulence Metrics The velocity field was measured using a Particle Image Velocimetry (PIV) system The mean velocity field and turbulent characteristics in the Y Z plane were analyzed Key turbulent characteristics obtained include the turbulent velocity u(rms) = ⟨u2y⟩ + ⟨u2z⟩1/2, the ratio between turbulent and mean velocities u(rms)/U, and the anisotropy parameter Au = u(rms)z /u(rms)y − 1.

Kai: The integral length scales ly and lz were determined from two-point velocity correlation functions.

Paper summary: Kai: We've just covered the general idea and what this paper is testing with these oscillating grids. The focus here is on how they set up the experiment and what they are measuring to prove the accumulative effect.

Mira: Right, so before we get into how they got those results, it helps to know their setup. They used air flows created by one and two oscillating grids in a chamber that was twenty-six centimeters by fifty-three centimeters by twenty-six centimeters.

Lev: That gives us a sense of the scale of the turbulence they are generating. The dimensions—twenty six by fifty three by twenty six—that sets the boundary conditions for what kind of flow we're looking at here.

Kai: Each grid was twenty five times twenty five centimeters, and they had a mesh size of five centimeters with a bar width of one centimeter, and these grids oscillated along the Y direction at a frequency of ten point five hertz with an amplitude of six centimeters.

Mira: And they placed the laser light sheet in the central vertical Y Z plane at an X coordinate of zero to get their measurements. They used borosilicate hollow glass particles that are approximately spherical in shape for their inertial particles.

Lev: That's good detail on the particle itself, because the size and shape of those particles really matter when you think about how they interact with the fluid motion described by this paper.

Kai: Next, they characterized the flow using a Particle Image Velocimetry system to measure both the mean velocity field and key turbulent characteristics in that Y Z plane.

Mira: They calculated several things like the turbulent velocity rms, which is defined as u squared y plus u squared z to the power of half, and then they look at that ratio of turbulent to mean velocities.

Lev: And they also found an anisotropy parameter, Au, which measures how different the turbulence is in the Y direction versus the Z direction. That tells you if it's isotropic or if there's a preferred direction in the turbulence structure.

Kai: They also determined integral length scales, l y and l z, by looking at two point velocity correlation functions to get an idea of those large-scale structures.

Conclusion: Mira: So, to wrap up the summary of this paper titled "Turbophoresis of inertial particles in inhomogeneous turbulence generated by oscillating grids," the main finding is that these particles cluster where the turbulence intensity is lowest.

Kai: The authors found that the ratio of their mean particle number densities, n in divided by nn in, which they call nin over nnin, is approximated by u squared Y times the mean square velocity times a constant kappa turboph τ zero minus alpha kappa turboph.

Lev: That equation shows how strongly it depends on the turbulence itself—the u squared Y term being key to that dependence.

Mira: And what this means for us is that this accumulation isn't just some minor boundary effect; it’s a bulk effect caused by those large-scale gradients of turbulence intensity across the flow field.

Kai: They explicitly state the spatial distribution doesn't show localization near the boundaries; instead, it follows the large scale variations of turbulence intensity, which is consistent with what they see in direct numerical simulations.

Mira: The normalized inertial-particle concentration increases in regions of reduced turbulence intensity, which matches what we expect from the turbophoretic trend seen in other models.

Lev: And they give us a terminal fall velocity for particles with a diameter of ten micrometers, and that’s about zero point three three centimeters per second, which is significantly smaller than both the typical mean fluid velocities and the turbulent ones.

Kai: The limitation they mention is that they didn't use these measurements to calculate a specific quantitative value for the turbophoretic coefficient kappa turboph itself; they just compared their observed spatial trend to previous theory and direct numerical simulations.

Mira: So, while this provides strong experimental evidence of large-scale turbophoretic particle accumulation in inhomogeneous turbulence, it doesn't give us a number for how strong the force is driving it yet.

Lev: The method itself relies on measurements with relatively short acquisition times and ensemble averaging over many independent realizations to get those density distributions.

Kai: This experimental setup gives us a concrete picture of how these particle drifts manifest in real air turbulence generated by oscillating grids, setting a clear benchmark for future theoretical work trying to quantify this effect.

More episodes

← Home