Alternate stabilization methods for CZTSSe photovoltaic devices by thermal treatment, dark electric bias and illumination
summary
The gist
Reliable measurement routines are crucial for power rating and yield prediction of photovoltaic emerging thinfilm technologies.
In short
This study investigated three methods to stabilize power measurements for Copper-Zinc-Tin-Sulfur-Selenium (CZTSSe) thin-film solar cells: rapid annealing, dark electric biasing, and operating under illumination. The findings indicate that dark electric biasing provides the most reliable average result for power stabilization. All tested methods showed potential to stabilize the devices for standardized measurement.
Key concepts
- CZTSSe Thin-Film Photovoltaic Devices
- These are emerging solar cells made from abundant elements like Copper, Zinc, Tin, Sulfur, and Selenium. They are considered promising for next-generation thin-film solar technology due to their low cost potential and high theoretical efficiency compared to traditional silicon cells.
- Rapid Annealing
- This is a thermal treatment method where the solar device is subjected to quick heating cycles. The study found that using this method, typically 3 to 6 cycles, can stabilize the power output, though it showed higher degradation in some parameters compared to other techniques.
- Dark Electric Biasing
- This technique involves applying an electric bias while keeping the device in darkness. The research determined that this specific method yielded the most reliable average result for stabilizing the power output of CZTSSe solar devices, suggesting it is a highly effective pre-conditioning routine.
Terminology used across episodes
This episode discusses
- Alternate stabilization methods for CZTSSe photovoltaic devices by thermal treatment, dark electric bias and illumination · Paper Radio
The paper
Alternate stabilization methods for CZTSSe photovoltaic devices by thermal treatment, dark electric bias and illumination · Read on arXiv
W. Ananda, M. Rennhofer, A. Mittal, N. Zechner, W. Lang
AIT Austrian Institute of Technology GmbH · University of Vienna
Reliable measurement routines are crucial for power rating and yield prediction of photovoltaic emerging thinfilm technologies. Copper-Zinc-Tin-Sulfur-Selenium (CZTSSe) thin-film photovoltaic devices are an emerging technology made of abundant elements. Still, sufficient stabilization methods prior to electric power measurement are missing in the international standardization, while existing standards for other thin-film technologies do not work properly for CZTSSe. This study investigated methods for achieving power stabilization of the CZTSSe solar devices. Three complementary stabilization routines for the kesterite-based solar devices were investigated as an alternative to the existing international device testing standards: rapid annealing, dark electric biasing and different operating points under illumination. The typical number of stabilization cycles for power stabilization was between 3 and 6 cycles of rapid annealing, dark electric bias and illumination with a power loss of-19.5%, -11.4%, and-1.9%, for the respective methods. The dark electric bias method was found to provide the most reliable average result for power stabilization. All stabilization methods proved to have the potential to work sufficiently in stabilizing the CZTSSe devices for standardized power measurement.
DOI: 10.1016/j.solener.2022.08.056
Transcript
Introduction to the show: ident: Physics. The day in general physics: instruments, methods and results across the field.
Kai: We're looking at the paper: "Alternate stabilization methods for CZTSSe photovoltaic devices by thermal treatment, dark electric bias and illumination".
Mira: Here's the gist of the paper. Reliable measurement routines are crucial for power rating and yield prediction of photovoltaic emerging thinfilm technologies.
Kai: This study investigated methods for achieving power stabilization of the CZTSSe solar devices.
Mira: The development of solar photovoltaic (PV) technologies is becoming more desirable in recent years for dealing with the decarbonization pathways to fulfill the 1.5 ◦C scenario as mandated by Paris Agreement (COP 21, 2015;
IRENA: - International Renewable Energy Agency, 2022).
Kai: Copper Zinc Tin Sulfur Selenium (CZTSSe) solar cells (also often referred to as kesterites) are seen by some as promising candidates for the next generation of thin-film (TF) PV because of their high theoretical efficiency, low-cost potential, and environmental friendliness.
Paper summary: Kai: So, looking at this paper, "Alternate stabilization methods for CZTSSe photovoltaic devices by thermal treatment, dark electric bias and illumination," it really sets out the thesis that reliable measurement routines are crucial for power rating and yield prediction of these emerging thin-film technologies >
Mira: And they claim that there's a gap because existing standards don't work properly for CZTSSe, and they propose three methods to bridge that gap: rapid annealing, dark electric biasing, and illumination under different operating points >
Lev: So the core idea is testing these specific pre-conditioning procedures to get a stable power output before measuring it against standard test conditions >
Kai: The paper tests these routines by looking at how many stabilization cycles are needed for each method to achieve that stability >
Mira: They found that for rapid annealing, the mean number of stabilization cycles was about three point two five cycles >
Lev: And they also looked at the dark electric bias method, which showed the best power stabilization according to their equation one, with seventy-five percent of their tested samples having values below two percent >
Kai: But then there are results for the illumination method too. For instance, route L3 on the illumination method during operation at twenty-five degrees Celsius shows the best stabilization with an average power rating variation of one point seven nine percent >
Mira: So it's a comparison between these three distinct approaches to see which one gives you a more reliable number >
Lev: And they summarize their comparative performance by looking at degradation in things like the short circuit current, fill factor, and power maximum power point >
Kai: They found that rapid annealing caused the highest degradation across those three parameters: the short circuit current, fill factor, and power maximum power point >
Mira: The dark electric bias method showed high degradation for open circuit voltage and low degradation for the fill factor >
Conclusion: Kai: So looking at "Alternate stabilization methods for CZTSSe photovoltaic devices by thermal treatment, dark electric bias and illumination," the authors conclude that route R1 is best for rapid annealing, D4 is best for dark electric bias, and L3 is best for illumination >
Mira: And they also suggest that they could develop the rapid annealing procedure further by increasing the annealing temperature above one hundred degrees Celsius >
Lev: The dark bias stabilization method seems useful because it's less time-consuming and doesn't need a special expensive setup to do it >
Kai: And the illumination method route L3 at twenty-five degrees Celsius could actually compete with the standardized route L1 at fifty degrees Celsius for power stabilization and performance >
Mira: It seems like they're suggesting that these methods offer real pathways to improve how we measure these CZTSSe devices so we can get consistent data >
More episodes
- 2610.36514-Integer electron-count cuts in variational second-order reduced-density-matrix theory. I. Molecular dissociation with fixed real-space and orbital partitions
- 2611.14082-Two atoms with strong light-induced dipolar interactions
- 2611.14040-Characterization of BNLs 20 and 30 micrometer thick LGADs for the Electron Ion Collider
- 2611.13399-Lift-element-based dynamic network of vortex gust-airfoil interactions
- 2611.13476-Hopfion Superlattices in 3D Twisted Moir'e Light Fields
- 2611.13642-Investigation of the timing performance of double-sided p-type 3D silicon sensors produced by CNM
- 2611.13830-SiPM optical readout of a PICOSEC Micromegas precise timing detector
- 2611.14152-Where are the shortest-path nodes in spatial networks?
- 2611.14219-Sub-Ice: semi-automated mapping of basal channels from ice shelf surface elevation data
- 2611.16341-SUMNO: Spatially Unrolled Multigrid Neural Operator for Fluid Flow Surrogates