Two-Dimensional Magnetic Materials from Ferromagnetism to Altermagnetism: Fabrication, Symmetry, Evidence, and Device Readiness
cond-mat.mtrl-sci, cond-mat.mes-hall, physics.app-ph
Submitted: 2026-10-28
Updated: 2026-10-28
Comments: 73 pages, 14 figures, 7 tables. Review published at Advanced Functional Materials
DOI: 10.1002/adfm.79184
License: http://creativecommons.org/publicdomain/zero/1.0/
The gist: Atomically thin magnets are governed by composition, thickness, stacking, strain, defects, substrates, ferroic order, and interfaces.
Terminology
Abstract
Atomically thin magnets are governed by composition, thickness, stacking, strain, defects, substrates, ferroic order, and interfaces. This Review organizes two-dimensional (2D) magnetism using net magnetization and momentum-space spin splitting or spin-polarization patterns as primary coordinates, supplemented by sublattice structure and the symmetry relations between opposite-spin sublattices. Ferromagnets generally carry a net moment; ferrimagnets can be fully compensated. Conventional antiferromagnets may retain spin-degenerate bands, while altermagnets permit nonrelativistic alternating spin splitting under dimension-specific symmetry constraints. M1-M4 reporting classes introduced here distinguish layer-resolved atomically thin forms, non-layer-resolved thin flakes or films, bulk benchmarks, and theoretical candidates or design routes; the evidence category and ordering-temperature provenance are reported independently. Current experimental support for altermagnetism comes mainly from M2 thin-film and M3 bulk benchmarks, leaving a fully verified atomically thin M1 altermagnetic phase as an open experimental goal. Most proposed monolayer and few-layer systems therefore fall within M4, and contested cases clarify the measurements needed for phase assignment. Device readiness is compared qualitatively using operating temperature, readout, switching, domain control, stability, scalability, interface sensitivity, and integration difficulty. Reliable phase assignment and device assessment require complementary measurements from the same material form under matched conditions, ideally on the same specimen or in situ.
Related papers
- Structural contribution to light-induced gap suppression in Ta 2 NiSe 5
- Anatomy of fast current-induced skyrmion motion in synthetic antiferromagnets
- Magnetic control of an exciton-polariton condensate in a van der Waals magnet
- High-pressure elastic properties of GeO2 polymorphs up to 120 GPa
- Decoupling Strain-Rate Sensitivity and Deformation Length Scale Effects in Neutron-Irradiated Tungsten: A Coupled Nano-Indentation, HR-EBSD and Crystal Plasticity Study
- Magnetism modulation in Co3Sn2S2 by current-assisted domain wall motion