Precision Mass Measurements of Te, Sn, and Their Impact on Models for R-Process Nucleosynthesis
Listen
Radio episode about this paper
Transcript
Introduction to the show: ident: Nuclear Experiment. The day in nuclear experiment: beams, targets and what came out.
Kai: I'm Kai.
Mira: And I'm Mira, here with Lev.
Kai: We're looking at the paper: "Precision Mass Measurements of Te, Sn, and Their Impact on Models for R-Process Nucleosynthesis".
Mira: Here's the gist of the paper. Precision mass measurements of 130Te, 130Sn, and Their Impact on Models for R-Process Nucleosynthesis show that new mass excesses are consistent with previous Penning trap measurements and have a significant impact on r-process abundance models Measurement Techniques The atomic mass measurements were performed at the Argonne Tandem Linac Accelerator System (ATLAS) facility, using the CAlifornium Rare Isotope Breeder Upgrade (CARIBU) facility as the ion source and the Canadian Penning Trap (CPT) mass spectrometer for measurements The PI-ICR technique was first developed at SHIPTRAP and is able to measure atomic mass with a relative precision of δm/m ≤ 10−8 The measurement involves measuring the cyclotron frequency, νc = qB/m, through the measurements of phase differences accumulated over a specified time in the trap using the relation νc = ∆ϕ + 2πN/2πtacc Mass Data Consistency The results for the 130Te mass excess were consistent with more precise AME2020 values and also agree with the 130Te → 130Xe Q-value from the CPT The new 130Sn mass excess is also a factor of two more precise than the previously most precise value from JYFLTRAP Furthermore, the extracted excitation energy of 1947.5(34) keV for the measured 130Snm isomer is consistent with the value obtained from gamma spectroscopy R-Process Modeling The new mass excesses were added to a SkyNet network calculation to determine their impact on r-process abundances and to find the best astrophysical conditions to reproduce the Solar System r-process abundance pattern The analysis involved scanning initial electron fractions, Ye, between 0.1 and 0.5, initial entropies per baryon between 50 kB and 500 kB, and expansion timescales τ between 1 ms and 1 s The conditions that most closely reproduce the solar r-process abundances were a Ye of 0.
Paper summary: Kai: So to summarize this paper, they took these precision mass measurements for 130Te, 130Sn, and 130Snm using the PI-ICR technique <ref:2603.05628#pg1>. The core thesis is that these new mass excesses are consistent with previous Penning trap measurements but have a significant impact on r-process abundance models.
Mira: They claim that these new values are important for determining the best astrophysical conditions—like electron fraction, entropy, and expansion timescale—needed to reproduce the solar system's r-process pattern.
Lev: The method described involves using the Argonne Tandem Linac Accelerator System at ATLAS as a facility and the Canadian Penning Trap at CPT for these measurements. They are using a technique where they measure the cyclotron frequency by looking at phase differences accumulated over time in the trap, which allows them to measure atomic mass with a relative precision of delta m over m less than ten to the power of negative eight.
Kai: That level of precision is what lets them get those specific mass excesses listed in Table one, comparing their results against AME, NUBASE, and SkyNet masses.
Mira: They show the 130Te mass excess is around minus eight thousand seven hundred thirty five point four keV compared to the SkyNet value of minus eight thousand seven hundred fifty-two point nine six zero zero one one <ref:2603.05628#pg1>.
Lev: The result for 130Sn is also detailed, showing a mass excess of minus eight thousand twelve point eight versus the SkyNet value of minus eighty thousand twelve point two with an uncertainty of one point nine <ref:2603.05628#pg1>.
Kai: And they even found that the extracted excitation energy for the 130Snm isomer is around one thousand nine hundred forty seven point five keV, which lines up with gamma spectroscopy data <ref:2603.05628#pg1>.
Mira: The paper also sets out a scanning process where they test initial electron fractions between zero point one and zero point five, initial entropies per baryon between fifty kilo-electron volts and fifty hundred kilo-electron volts, and expansion timescales tau between one millisecond and one second.
Lev: And the conclusion from that scan is that the conditions that most closely reproduce the solar r-process abundances are when the electron fraction Ye is at zero point zero.
Conclusion: Kai: So looking at the whole thing, the authors are showing how getting these precise mass measurements for 130Te, 130Sn, and 130Snm isn't just a technical achievement in measuring atoms <ref:2603.05628#pg1>.
Mira: It’s about taking those precise inputs and feeding them into larger astrophysical models like SkyNet to see what kind of environment—what electron fraction, what temperature—is needed for the r-process to actually make the elements we see in our solar system.
Lev: The implication is that better mass measurements translate directly into tighter constraints on the physical conditions during an r-process event, which is super hard to study because it happens under extreme conditions.
Kai: It means that when we try to model where heavy elements come from, we have better starting numbers now for the nuclear physics side of those simulations.
Mira: So this paper shows that by getting better data on these specific isotopes, we can narrow down the possible physical conditions significantly when trying to explain the solar r-process abundance pattern.
Lev: It's about moving from a broad range of possibilities to a much more focused set of astrophysical parameters for these extreme nucleosynthesis scenarios.
Department of Physics and Astronomy, University of Notre Dame · Physics Division, Argonne National Laboratory · Department of Physics and Astronomy, University of Manitoba · Department of Physics and Astronomy, Louisiana State University · Department of Physics, University of Chicago
nucl-ex
Submitted: 2026-03-05
Updated: 2026-11-10
License: http://creativecommons.org/licenses/by/4.0/
Importance score: 91/100
The gist: Precision mass measurements of 130Te, 130Sn, and Their Impact on Models for R-Process Nucleosynthesis show that new mass excesses are consistent with previous Penning trap measurements and have a…
Key concepts
- Mass Excess
- This is a value added to the atomic mass of an isotope to make calculations easier. It represents the energy required to remove an electron from a neutral atom, and precise measurements help refine nuclear models.
- Penning Trap (CPT)
- A type of mass spectrometer used for these measurements. It uses magnetic fields and frequency measurements to determine the mass of ions with very high relative precision, allowing for accurate isotope identification.
- R-Process Nucleosynthesis
- This is a nuclear reaction process that occurs in extreme astrophysical events, like neutron star mergers. It explains how heavy elements beyond iron are created in the universe.
Terminology
Summary
Precision mass measurements of 130Te, 130Sn, and Their Impact on Models for R-Process Nucleosynthesis show that new mass excesses are consistent with previous Penning trap measurements and have a significant impact on r-process abundance models
Measurement Techniques
The atomic mass measurements were performed at the Argonne Tandem Linac Accelerator System (ATLAS) facility, using the CAlifornium Rare Isotope Breeder Upgrade (CARIBU) facility as the ion source and the Canadian Penning Trap (CPT) mass spectrometer for measurements The PI-ICR technique was first developed at SHIPTRAP and is able to measure atomic mass with a relative precision of δm/m ≤ 10−8 The measurement involves measuring the cyclotron frequency, νc = qB/m, through the measurements of phase differences accumulated over a specified time in the trap using the relation νc = ∆ϕ + 2πN/2πtacc
Mass Data Consistency
The results for the 130Te mass excess were consistent with more precise AME2020 values and also agree with the 130Te → 130Xe Q-value from the CPT The new 130Sn mass excess is also a factor of two more precise than the previously most precise value from JYFLTRAP Furthermore, the extracted excitation energy of 1947.5(34) keV for the measured 130Snm isomer is consistent with the value obtained from gamma spectroscopy
R-Process Modeling
The new mass excesses were added to a SkyNet network calculation to determine their impact on r-process abundances and to find the best astrophysical conditions to reproduce the Solar System r-process abundance pattern The analysis involved scanning initial electron fractions, Ye, between 0.1 and 0.5, initial entropies per baryon between 50 kB and 500 kB, and expansion timescales τ between 1 ms and 1 s The conditions that most closely reproduce the solar r-process abundances were a Ye of 0. p. 3 After initial scans of the parameter space, the conditions that most closely reproduce the solar r-process
abundances were a Ye of 0. 3725(25), an expansion
timescale of 210(5)ms, and an entropy per baryon of
435(5)kB.Where the paper says it
Green — the paper says it, and the page is printed. Red — no passage carries it, so treat that sentence as unverified. The same check runs on your own text: check a summary against its source, $5.
Improvements for AI systems
-
Improve mass input accuracy for r-process models by incorporating new measurements of neutron-rich isotopes like 130Te, 130Sn, and 130Snm into nuclear physics datasets used by simulations like SkyNet. This allows AI systems to determine
which initial astrophysical conditions best reproduce the Solar System r-process abundance pattern.
-
Enhance model sensitivity for determining r-process scenarios by using the updated mass inputs to calculate impact parameters F = 100X A X(A) − Xb(A) for different conditions. This allows AI systems to quantify how
the updated 130Te and 130Sn masses had the largest impact on the light r-process, Y3.
-
Refine scenario selection by using a linear combination of abundance patterns from optimal conditions (Y1, Y2, Y3) as input for fitting. This provides a
better representation of the solar abundance data
and achieves a30% reduction in the reduced chi squared of the fit to solar data.
Abstract
The astrophysical rapid neutron capture nucleosynthesis process (r-process) remains an active area of research due to the fact that it occurs in extreme conditions and involves reactions with exotic nuclei that are difficult to study experimentally. For the first time using the Phase-Imaging Ion Cyclotron Resonance (PI-ICR) technique, we measured the mass excesses of Te, Sn, and Sn with the Canadian Penning Trap (CPT). Our results show good agreement with previous Penning trap values obtained using the Time-of-Flight Ion Cyclotron Resonance (TOF-ICR) and the Fourier Transform Ion Cyclotron Resonance (FT-ICR) techniques, while being twice as precise for Sn. These new mass excesses were added to a SkyNet network calculation to determine their impact on r-process abundances and to find the best astrophysical conditions to reproduce the Solar System r-process abundance pattern. Finally, by treating lighter and heavier elements separately, we assess the relative frequency of events producing elements in a cold versus a hot r-process scenario.
Sources
Related papers
- Regularity of core coupled high-spin structure in neutron-rich 196-202 Au isotopes approaching N =126
- Precise and accurate nuclear electric quadrupole moment of 223 Ra from molecular spectroscopy
- A pathway towards decentralized studies of radioactive post-lead elements and their applications in beyond standard model physics
- Analysis of Xe-131 Prompt Gammas
- Probing the initial geometry and the onset of collectivity with anisotropic flow in light-ion collisions with ALICE at the LHC
- Heavy-Quark Dynamics from D 0-Meson Anisotropy-Response Scaling Violations