Precision Mass Measurements of Te, Sn, and Their Impact on Models for R-Process Nucleosynthesis
summary
The gist
Precision mass measurements of 130Te, 130Sn, and Their Impact on Models for R-Process Nucleosynthesis show that new mass excesses are consistent with previous Penning trap measurements and have a…
In short
Precision mass measurements of isotopes like 130Te and 130Sn were conducted using advanced techniques at ATLAS and CPT facilities. These new mass excesses align with previous findings, significantly impacting models used to predict the abundances created during the rapid neutron capture process (r-process) in astrophysics.
Key concepts
- Mass Excess
- This is a value added to the atomic mass of an isotope to make calculations easier. It represents the energy required to remove an electron from a neutral atom, and precise measurements help refine nuclear models.
- Penning Trap (CPT)
- A type of mass spectrometer used for these measurements. It uses magnetic fields and frequency measurements to determine the mass of ions with very high relative precision, allowing for accurate isotope identification.
- R-Process Nucleosynthesis
- This is a nuclear reaction process that occurs in extreme astrophysical events, like neutron star mergers. It explains how heavy elements beyond iron are created in the universe.
Terminology used across episodes
This episode discusses
- Precision Mass Measurements of Te, Sn, and Their Impact on Models for R-Process Nucleosynthesis · Paper Radio
- Mass measurements of neutron-rich nuclides using the Canadian Penning Trap to inform predictions in the r-process rare-earth peak region
The paper
Precision Mass Measurements of Te, Sn, and Their Impact on Models for R-Process Nucleosynthesis · Read on arXiv
Department of Physics and Astronomy, University of Notre Dame · Physics Division, Argonne National Laboratory · Department of Physics and Astronomy, University of Manitoba · Department of Physics and Astronomy, Louisiana State University · Department of Physics, University of Chicago
The astrophysical rapid neutron capture nucleosynthesis process (r-process) remains an active area of research due to the fact that it occurs in extreme conditions and involves reactions with exotic nuclei that are difficult to study experimentally. For the first time using the Phase-Imaging Ion Cyclotron Resonance (PI-ICR) technique, we measured the mass excesses of Te, Sn, and Sn with the Canadian Penning Trap (CPT). Our results show good agreement with previous Penning trap values obtained using the Time-of-Flight Ion Cyclotron Resonance (TOF-ICR) and the Fourier Transform Ion Cyclotron Resonance (FT-ICR) techniques, while being twice as precise for Sn. These new mass excesses were added to a SkyNet network calculation to determine their impact on r-process abundances and to find the best astrophysical conditions to reproduce the Solar System r-process abundance pattern. Finally, by treating lighter and heavier elements separately, we assess the relative frequency of events producing elements in a cold versus a hot r-process scenario.
Transcript
Introduction to the show: ident: Nuclear Experiment. The day in nuclear experiment: beams, targets and what came out.
Kai: I'm Kai.
Mira: And I'm Mira, here with Lev.
Kai: We're looking at the paper: "Precision Mass Measurements of Te, Sn, and Their Impact on Models for R-Process Nucleosynthesis".
Mira: Here's the gist of the paper. Precision mass measurements of 130Te, 130Sn, and Their Impact on Models for R-Process Nucleosynthesis show that new mass excesses are consistent with previous Penning trap measurements and have a significant impact on r-process abundance models Measurement Techniques The atomic mass measurements were performed at the Argonne Tandem Linac Accelerator System (ATLAS) facility, using the CAlifornium Rare Isotope Breeder Upgrade (CARIBU) facility as the ion source and the Canadian Penning Trap (CPT) mass spectrometer for measurements The PI-ICR technique was first developed at SHIPTRAP and is able to measure atomic mass with a relative precision of δm/m ≤ 10−8 The measurement involves measuring the cyclotron frequency, νc = qB/m, through the measurements of phase differences accumulated over a specified time in the trap using the relation νc = ∆ϕ + 2πN/2πtacc Mass Data Consistency The results for the 130Te mass excess were consistent with more precise AME2020 values and also agree with the 130Te → 130Xe Q-value from the CPT The new 130Sn mass excess is also a factor of two more precise than the previously most precise value from JYFLTRAP Furthermore, the extracted excitation energy of 1947.5(34) keV for the measured 130Snm isomer is consistent with the value obtained from gamma spectroscopy R-Process Modeling The new mass excesses were added to a SkyNet network calculation to determine their impact on r-process abundances and to find the best astrophysical conditions to reproduce the Solar System r-process abundance pattern The analysis involved scanning initial electron fractions, Ye, between 0.1 and 0.5, initial entropies per baryon between 50 kB and 500 kB, and expansion timescales τ between 1 ms and 1 s The conditions that most closely reproduce the solar r-process abundances were a Ye of 0.
Paper summary: Kai: So to summarize this paper, they took these precision mass measurements for 130Te, 130Sn, and 130Snm using the PI-ICR technique <ref:2603.05628#pg1>. The core thesis is that these new mass excesses are consistent with previous Penning trap measurements but have a significant impact on r-process abundance models.
Mira: They claim that these new values are important for determining the best astrophysical conditions—like electron fraction, entropy, and expansion timescale—needed to reproduce the solar system's r-process pattern.
Lev: The method described involves using the Argonne Tandem Linac Accelerator System at ATLAS as a facility and the Canadian Penning Trap at CPT for these measurements. They are using a technique where they measure the cyclotron frequency by looking at phase differences accumulated over time in the trap, which allows them to measure atomic mass with a relative precision of delta m over m less than ten to the power of negative eight.
Kai: That level of precision is what lets them get those specific mass excesses listed in Table one, comparing their results against AME, NUBASE, and SkyNet masses.
Mira: They show the 130Te mass excess is around minus eight thousand seven hundred thirty five point four keV compared to the SkyNet value of minus eight thousand seven hundred fifty-two point nine six zero zero one one <ref:2603.05628#pg1>.
Lev: The result for 130Sn is also detailed, showing a mass excess of minus eight thousand twelve point eight versus the SkyNet value of minus eighty thousand twelve point two with an uncertainty of one point nine <ref:2603.05628#pg1>.
Kai: And they even found that the extracted excitation energy for the 130Snm isomer is around one thousand nine hundred forty seven point five keV, which lines up with gamma spectroscopy data <ref:2603.05628#pg1>.
Mira: The paper also sets out a scanning process where they test initial electron fractions between zero point one and zero point five, initial entropies per baryon between fifty kilo-electron volts and fifty hundred kilo-electron volts, and expansion timescales tau between one millisecond and one second.
Lev: And the conclusion from that scan is that the conditions that most closely reproduce the solar r-process abundances are when the electron fraction Ye is at zero point zero.
Conclusion: Kai: So looking at the whole thing, the authors are showing how getting these precise mass measurements for 130Te, 130Sn, and 130Snm isn't just a technical achievement in measuring atoms <ref:2603.05628#pg1>.
Mira: It’s about taking those precise inputs and feeding them into larger astrophysical models like SkyNet to see what kind of environment—what electron fraction, what temperature—is needed for the r-process to actually make the elements we see in our solar system.
Lev: The implication is that better mass measurements translate directly into tighter constraints on the physical conditions during an r-process event, which is super hard to study because it happens under extreme conditions.
Kai: It means that when we try to model where heavy elements come from, we have better starting numbers now for the nuclear physics side of those simulations.
Mira: So this paper shows that by getting better data on these specific isotopes, we can narrow down the possible physical conditions significantly when trying to explain the solar r-process abundance pattern.
Lev: It's about moving from a broad range of possibilities to a much more focused set of astrophysical parameters for these extreme nucleosynthesis scenarios.
More episodes
- 2602.10658-Inclusive and multiplicity-dependent pseudorapidity densities of charged particles in pp collisions at sqrt s = 13.6 TeV
- 2606.07905-Precision cross section measurements of neutron-induced non-elastic gamma production reactions at 14 MeV
- The day in conversation for 2026-11-16
- Daily Summary for 2026-11-16
- 2504.07795-Measurement of coincident photon-initiated processes in ultra-peripheral Pb+Pb collisions with the ATLAS detector
- 2611.16075-Exclusive cross section measurements of 12 C(n,p n) and 12 C(n,d n) reactions
- 2611.17010-Observation of the lambda(1520) suppression in Pb-Pb collisions at sqrt s NN = 5.02 TeV
- The day in conversation for 2026-11-15
- Daily Summary for 2026-11-15
- 2611.08725-Probing the initial geometry and the onset of collectivity with anisotropic flow in light-ion collisions with ALICE at the LHC