Surface-Dominated Anomalous Hall Effect in Altermagnetic MnTe Films

arXiv:2602.09363 · cond-mat.mtrl-sci, cond-mat.mes-hall · Submitted 2026-02-10 · Read on arXiv

Listen

Radio episode about this paper

Transcript

Introduction to the show: ident: Condensed Matter. The day in condensed matter: materials, phases and the measurements under them.

Kai: We're looking at the paper: "Surface-Dominated Anomalous Hall Effect in Altermagnetic MnTe Films".

Mira: Here's the gist of the paper. Surface-state-driven anomalous hall effect in altermagnetic MnTe films establishes that the anomalous Hall response originates from Berry curvature of surface states rather than bulk bands.

Kai: Discovery of Altermagnetism and Electronic Structure Altermagnets represent a new magnetic phase where compensated collinear magnetic order coexists with a large momentum-dependent spin splitting.

Mira: This unique property means that opposite spin sublattices are connected by crystal symmetry operations rather than inversion or translation symmetries, resulting in vanishing net magnetization but spin-polarized band structures and finite Berry curvature even without spin-orbit coupling.

Kai: Angle-resolved photoemission spectroscopy (ARPES) measurements reveal a large spin splitting of 230 meV for the bulk valence band near the Fermi level, directly confirming the altermagnetic band structure.

Title and authors: Kai: Now, let's dig into what the paper actually claims about this phenomenon. The title itself sets up this idea of surface dominance in an altermagnetic MnTe film regarding the anomalous Hall effect >

Mira: It’s proposing that the mechanism isn't something you get from conventional ferromagnets or antiferromagnets, but something unique arising from these materials that have vanishing net magnetization >

Lev: So we're dealing with a system where spin-polarized band structures exist even without spin-orbit coupling in some cases, which is unusual for most magnetic systems I know >

Kai: Right. And the paper uses angle resolved photoemission spectroscopy or ARPES to show this momentum resolution evidence for the altermagnetic band structure, revealing a large spin splitting of about two hundred thirty millivolts for bulk bands near the Fermi level >

Mira: That large spin splitting is key because it confirms that this unusual magnetic order actually exists at the electronic level, even if the macroscopic magnetization is zero >

Lev: From my point of view, ARPES provides direct evidence of that band structure, which is crucial because many transport measurements only give you an average response from many different states >

Kai: And they connect this bulk altermagnetic order to the surface states by showing that the AH sign is determined by the bulk altermagnetic order rather than just the magnetization direction of the surface MnTe layer >

The paper's summary: Mira: So, summarizing what we've covered, they found a robust anomalous Hall effect persisting down to two Kelvin and they also saw this sign reversal happening near one hundred seventy five Kelvin >

Kai: And the big takeaway is that by systematically tuning the film thickness and the interface structure, they demonstrated that this anomalous Hall response originates from the Berry curvature of surface states rather than from bulk bands >

Lev: That’s a big deal because it means we can use these surfaces as a probe to understand something happening deep inside the bulk, which is often hard to access >

Mira: They also showed that interface engineering is an effective route to generating and controlling the anomalous Hall effect in altermagnets, and they proved this response remains unchanged even when you change the direction of the Mn magnetic orientation on either side of a termination >

Kai: And they quantify this surface state contribution by calculating it to be in the range of negative two microseconds to positive two microseconds for sigma sub x sub y conductivity >

Lev: So, essentially, they’ve established a unique surface transport probe for bulk altermagnetism and shown that you can use interface engineering to control the anomalous Hall effect >

The paper's improvements: Kai: They suggest several improvements to this understanding. For instance, they show how tuning the film thickness and growth conditions allows you to manipulate the AH response in a way that’s controlled by symmetry operations like rotations or glide planes >

Mira: And they provide a clearer picture of how different surface channels at those top and bottom interfaces contribute differently, giving us a mechanism for why we see those two competing signs >

Lev: If we were trying to build hardware based on this, the improvement is knowing precisely which interface—the top one or the bottom one—is responsible for which sign of the contribution >

Kai: They also show how they can use this surface-state-driven response to create a unified understanding of how anomalous Hall response works across different terminations of these altermagnetic MnTe films >

Mira: This moves us toward having a more predictable way to engineer the effect by focusing on controlling those specific interfacial properties, which is what you need for practical applications >

Conclusion: Kai: To wrap up, the paper "Surface-Dominated Anomalous Hall Effect in Altermagnetic MnTe Films" establishes that the anomalous Hall response in altermagmatic MnTe films comes from surface states rather than bulk bands >

Mira: And they show that interface engineering is a key way to generate and control this effect, showing it's imprinted by the bulk altermagnetic order even when you flip the surface magnetic orientation >

Lev: From an error correction standpoint, this gives us a new way to look at material characterization where we can use surface transport to probe the bulk magnetic order in a predictable manner >

Kai: It opens up using these surfaces as a way to study bulk physics without needing extremely deep probes, which is really important for experimental setups like ours >

Mira: Yeah, it’s about unifying our understanding of how this response behaves across different terminations of these altermagnetic MnTe films and pointing toward interface engineering as the path forward >

Ling-Jie Zhou, Zi-Jie Yan, Hongtao Rong, Yufei Zhao, Pu Xiao, Lok-Kan Lai, Zhiyuan Xi, Ke Wang, Tibendra Adhikari, Ganesh P. Tiwari, Zhong Lin, Pascal Manuel, Fabio Orlandi, Dmitry Khalyavin, Alexander J. Grutter, Chao-Xing Liu, Binghai Yan, Cui-Zu Chang

Department of Physics at The Pennsylvania State University · Department of Condensed Matter Physics at Weizmann Institute of Science · Materials Research Institute at The Pennsylvania State University · Department of Physics, Applied Physics and Astronomy at Binghamton University · Materials Science and Engineering Program at Binghamton University · ISIS Neutron and Muon Source at STFC Rutherford Appleton Laboratory, Harwell Campus OX11 0QX, Oxfordshire, UK · Center for Neutron Research at National Institute of Standards and Technology

cond-mat.mtrl-sci, cond-mat.mes-hall

Submitted: 2026-02-10

Updated: 2026-11-06

Comments: 25 pages, 5 figures, comments are very much welcome

License: http://arxiv.org/licenses/nonexclusive-distrib/1.0/

Importance score: 98/100

The gist: Surface-state-driven anomalous hall effect in altermagnetic MnTe films establishes that the anomalous Hall response originates from Berry curvature of surface states rather than bulk bands.

Key concepts

Altermagnetism
A new magnetic phase where collinear magnetic order coexists with a large momentum-dependent spin splitting. This unique structure means opposite spin sublattices are connected by crystal symmetry operations instead of standard inversion or translation symmetries, leading to finite Berry curvature even without spin-orbit coupling.
Anomalous Hall Effect (AHE)
A transport phenomenon where the electrical resistance depends on the magnetic field direction. In this study, it is shown that the AHE in MnTe films originates from surface states with Berry curvature rather than bulk electronic bands, which is crucial for understanding its origin.
Berry Curvature
A geometric property of electronic band structures that acts like an effective magnetic field in momentum space. The paper demonstrates that this curvature arising from surface states is the source of the anomalous Hall response observed in these materials, replacing traditional bulk band explanations.

Terminology

Summary

Surface-state-driven anomalous hall effect in altermagnetic MnTe films establishes that the anomalous Hall response originates from Berry curvature of surface states rather than bulk bands. p. 1

Discovery of Altermagnetism and Electronic Structure

Altermagnets represent a new magnetic phase where compensated collinear magnetic order coexists with a large momentum-dependent spin splitting. This unique property means that opposite spin sublattices are connected by crystal symmetry operations rather than inversion or translation symmetries, resulting in vanishing net magnetization but spin-polarized band structures and finite Berry curvature even without spin-orbit coupling. p. 2 Angle-resolved photoemission spectroscopy (ARPES) measurements reveal a large spin splitting of 230 meV for the bulk valence band near the Fermi level, directly confirming the altermagnetic band structure. p. 2

Evidence of Surface-Dominated Transport

Electrical transport measurements uncover a robust anomalous Hall effect persisting down to 2 K and a pronounced sign reversal near 175 K. The longitudinal resistance of MnTe films shows a weak thickness dependence for d ≥ 5, indicating surface-dominated conduction. p. 3 Furthermore, the d dependence of resistivity at T = 2 K shows a pronounced reduction as d increases from 1 to 5, followed by a nearly saturated behavior for d ≥ 5. p. 6 This weak d dependence of resistivity (T=2K), together with its slight increase at larger d indicates that electrical transport in MBE-grown MnTe films on InP(111)A is dominated by surface states rather than bulk states. p. 6

Mechanism of the Anomalous Hall Effect

The authors identify two competing anomalous Hall contributions of opposite signs, which they attribute to distinct surface channels at the top Te-capping/MnTe and bottom MnTe/InP interfaces. First-principles calculations identify distinct surface states at these two interfaces with opposite AH conductivity and reveal their intimate connection to the bulk altermagnetic order. p. 3 The AH sign is determined by the bulk altermagnetic order, rather than by the magnetization direction of the surface MnTe layer, even though the AH effect originates from the top and bottom surface layers. p. 1

Role of Interface Engineering

The work demonstrates interface engineering as a key mechanism for inducing Berry curvature and generating the AH effect in altermagnets. The AH response is imprinted by the bulk altermagnetic order and remains unchanged for terminations with opposite Mn magnetic orientations. p. 1 The analysis of surface-state contributions to the Hall conductivity shows that the calculated surface xy is on the order of 1 µS, in good agreement with the experimentally extracted values of - 2 µS < σxy < 2 µS. p. 9

Green — the paper says it, and the page is printed. Red — no passage carries it, so treat that sentence as unverified. The same check runs on your own text: check a summary against its source, $5.

Improvements for AI systems

  1. Improved AI system can precisely predict anomalous Hall effect sign reversals by analyzing film thickness, growth conditions, and interfacial structure, as demonstrated by identifying two competing AH contributions of opposite signs originating from distinct surface channels at the top Te-capping/MnTe and bottom MnTe/InP interfaces.

  2. Improved AI system can distinguish between bulk band contributions and surface state contributions to transport properties in altermagnetic materials like MnTe, utilizing ARPES data which reveal a large spin splitting of ~230 meV for the bulk valence band near the Fermi level while simultaneously confirming that transport is dominated by surface states rather than bulk bands.

  3. Improved AI system can predict the dominance of different anomalous Hall components based on temperature and film thickness, as shown by observing that the positive AH component dominates for T ≥ 200 K while the negative AH component becomes dominant for T = 2 K in the d=230 film.

  4. Improved AI system can determine the origin of the anomalous Hall effect sign based on symmetry operations, as evidenced by finding that the AH sign is determined by the bulk altermagnetic order, rather than by the magnetization direction of the surface MnTe layer.

  5. Improved AI system can model and predict surface conductivity contributions to anomalous Hall effect using first-principles calculations, calculating that at E ~ -0.2 eV, the top Te/MnTe and bottom MnTe/InP surface bands contribute -8.4 us and +0.7 us to sigmaxy.

Sources

Related papers