Quantitative Junction Transport Modeling of RHIC Charge and Baryon Stopping

summary

The gist

Charge and baryon stopping in Ru+Ru and Zr+Zr isobar collisions are modeled by HIJING with junction.

In short

The study uses HIJING with a baryon junction model to reproduce STAR data on net-baryon yield and charge difference in Ru+Ru and Zr+Zr collisions. The junction sets the magnitude of the baryon transport ratio, while nuclear neutron skins determine its centrality trend. This provides a quantitative benchmark for baryon transport.

Key concepts

Baryon Junction
This is a Y-shaped configuration of soft gluon fields connecting the three valence quarks of a baryon. It traces the baryon number and carries only a small fraction of the nucleon's momentum, allowing it to stop near midrapidity in high-energy collisions.
Junction Exchange Cross Section (σJ)
The model incorporates an exchange mechanism where a baryon is formed from the junction and three sea quarks. This cross section is tuned to 28 mb and reproduces the observed net-baryon yield in isobar collisions, showing its role in baryon transport.
Neutron Skins
The nuclear structure, specifically the neutron skins of Ru and Zr isobars, dictates the centrality dependence of observables. These skins affect how many protons participate in peripheral collisions versus central ones, influencing the charge difference and scaled ratio.

Terminology used across episodes

This episode discusses

The paper

Quantitative Junction Transport Modeling of RHIC Charge and Baryon Stopping · Read on arXiv

Ashish Pandav, *Zhangbu Xu, †Bedangadas Mohanty

Center for Nuclear Research, Department of Physics, Kent State University · School of Physical Sciences, National Institute of Science Education and Research, HBNI

Transcript

Introduction to the show: ident: Nuclear Theory. The day in nuclear theory: structure, reactions and the models behind them.

Kai: I'm Kai.

Mira: And I'm Mira, here with Lev.

Kai: We're looking at the paper: "Quantitative Junction Transport Modeling of RHIC Charge and Baryon Stopping".

Mira: Here's the gist of the paper. Charge and baryon stopping in Ru+Ru and Zr+Zr isobar collisions are modeled by HIJING with junction.

Kai: The tuned generator reproduces STAR’s netbaryon yield, charge difference, and scaled baryon-to-charge ratio at midrapidity.

Mira: Junctions set the ratio’s magnitude while neutron skins drive its centrality trend.

Kai: This tuned generator reproduces RHIC data and predicts O+O behavior, setting a quantitative benchmark for baryon transport.

Paper summary: Kai: So we're looking at this paper, "Quantitative Junction Transport Modeling of RHIC Charge and Baryon Stopping." This work uses HIJING with a junction to model charge and baryon stopping in ruthenium plus ruthenium and zirconium plus zirconium collisions. The authors claim that tuning the generator reproduces STAR’s netbaryon yield, charge difference, and scaled baryon-to-charge ratio at midrapidity.

Mira: That means they're proposing a model where this junction plays a specific role in how baryons stop in these heavy ion collisions. What’s interesting is how they use the junction to set the magnitude of that ratio while the neutron skins of these nuclei drive its centrality trend.

Lev: From an engineering standpoint, what we need to watch is how much overhead this modeling adds when we try to run it on real hardware. The paper focuses on tuning parameters like sigma J equals twenty-eight millibarns and lambda J equals zero point five five to match the measured rapidity slope of the net-proton distribution in Au plus Au collisions.

Kai: So, what they're doing is looking at an alternative picture for baryon number transport, where you have a Y shaped configuration of gluons called a baryon junction that traces the baryon number. This object is made of soft gluons and carries a small fraction of the nucleon momentum, allowing it to stop near midrapidity in high-energy collisions while the valence quarks keep moving toward the beam rapidity.

Mira: And they are using this junction concept to build into their HIJING version two point zero. They enable baryon junction exchange with a cross section of twenty-eight millibarns, which reproduces the netbaryon yield in the isobars. A baryon is formed from that junction and three sea quarks, and its rapidity samples from exp(lambda J y) between the outermost string ends, carrying baryon number without transporting charge.

Lev: I see them also increase the effective string tension above a value of one gigaparsec per fermi in nucleus plus nucleus collisions, using kappa equals two times that value for these collisions and one point five times that value for proton plus proton collisions. They mention that this enhanced string tension is another physics addition in this version two point zero.

Paper summary: Kai: So, the results they get by adjusting parameters like the quark diquark splitting probability Pu to zero point five eight match the charge difference observable while midrapidity hadron yields are insensitive to it. This suggests a specific relationship between these variables in their model.

Mira: And when they switch off the junction mechanism, the charge difference observable remains essentially unchanged, comparing one point zero to one point four times ten to the minus three versus one point one to one point three times ten to the minus three with it on. That’s a bit surprising because it shows that this junction exchange contributes about half of the midrapidity netbaryon number but doesn't affect the charge difference observable at all.

Lev: I gotta ask, if it only affects the baryon number and not charge, what does that tell us about how we actually measure these quantities in an experiment? It sounds like a specific signature.

Kai: The paper also compares their model to Au plus Au and proton plus proton baryon sectors at the level of experimental uncertainties. Specifically for O plus O collisions at the same average number of participants as peripheral isobar collisions, they predict a specific ordering for the net-baryon number per participant, charge difference, and scaled ratio across the Ru minus Zr, O minus Ru and O minus Zr pairs.

Mira: That ordering they predict is that in charge difference we get O minus Ru less than ruthenium minus zirconium less than oxygen minus zirconium. And in the scaled ratio we get ruthenium minus zirconium less than oxygen minus zirconium less oxygen minus ruthenium.

Lev: That prediction about the scaling of those ratios is where I need to be careful. It depends heavily on the nuclear structure details they are inputting for these isobars, specifically those neutron skins which they suggest drive that centrality dependence.

Kai: They link that centrality trend in the scaled ratio directly to the neutron skins of the isobars, and they say that removing this deformation doesn't change either charge difference or the scaled ratio beyond statistical uncertainties. The oxygen minus zirconium pair is highlighted as being the best determined because it has a large lever.

Paper summary: Mira: So, what this means for us is that we have two separate things setting those two different parts of the ratio: the junction sets its magnitude, and then nuclear geometry provides its centrality dependence.

Lev: And I need to point out a limitation here. The paper mentions that at LHC energies, large asymmetric pair production in HIJING can obscure these junction effects, causing apparent tension with data. They also say that this tuned generator is constrained to string fragmentation at LHC multiplicities rather than baryon transport itself, which suggests the junction version of HIJING might not be directly applicable for those high energy regimes.

Kai: So, if we look at the full scope of "Quantitative Junction Transport Modeling of RHIC Charge and Baryon Stopping," it boils down to this: the junction component sets the magnitude of that ratio, with turning it off giving a range from zero point four to zero point nine like models without junctions.

Mira: And because the neutron skins are what drive the centrality dependence, those skins are crucial for understanding how baryon transport scales across different collision centralities. This model predicts a specific ordering for O plus O collisions at peripheral isobar collisions' average number of participants, which STAR data can test.

Lev: It’s interesting that they also found that between two hundred and nine hundred gigaparsecs per fermi, the junction component falls by a factor of zero point three seven, which is consistent with what we actually measure in other experiments.

Kai: So to wrap up the paper's main contribution, it reproduces STAR isobar measurements at two hundred gigaparsecs per fermi in all centrality classes. The junction sets its magnitude, and the neutron skins set its centrality dependence.

Mira: And for O plus O collisions at peripheral isobar collisions' average number of participants, the model predicts the ordering of pairs which STAR data can test. That seems like a solid quantitative benchmark for how baryon transport works in these systems.

Conclusion: Kai: So we've looked at how this paper, "Quantitative Junction Transport Modeling of RHIC Charge and Baryon Stopping," uses these isobars to explain how charge and baryons stop in collisions at two hundred gigaparsecs per fermi.

Mira: It’s basically about using a new idea called the baryon junction to model this transport, which they show matches the data from STAR experiments pretty well across different centrality classes.

Lev: From an engineering standpoint, what's cool is that they tuned their HIJING generator with parameters like sigma J equals twenty-eight millibarns and lambda J equals zero point five five to get those yields right.

Kai: And the authors are suggesting that this junction sets the magnitude of the charge difference ratio, while the neutron skins of these nuclei control how that ratio changes as you move from central to peripheral collisions.

Mira: So what they're really saying is that you have two separate things setting up that final number, one part from the junction mechanism and another part from how much stuff is in the nucleus.

Lev: The authors also point out a scaling issue, showing that this junction contribution drops by about thirty-seven percent when you go from two hundred gigaparsecs per fermi to nine hundred gigaparsecs per fermi.

Kai: It’s interesting because they say that at nine hundred gigaparsecs per fermi, the junction component by itself accounts for the whole net proton yield, suggesting that extra protons in those high-energy events come from pair asymmetry instead.

Mira: That implies a certain kind of behavior for baryon transport at very high energies that we need to keep an eye on as we look at future data.

Lev: It's a lot of assumptions packed into this model, and it really pushes the limits on what these phenomenological models can actually predict before we get real hardware running them.

More episodes

← Home