Calculating extremely high energy bremsstrahlung in matter

summary

The gist

Ultra-relativistic electrons initiate electromagnetic showers in ordinary matter that evolve through bremsstrahlung and pair production.

In short

The paper investigates how ultra-relativistic electrons lose energy via bremsstrahlung and pair production in matter at lower energies than previously studied. It extends the Landau-Pomeranchuk-Migdal (LPM) effect by including electron mass and medium-induced photon mass, finding that overlapping pair production disrupts LPM suppression, significantly increasing the bremsstrahlung rate.

Key concepts

Landau-Pomeranchuk-Migdal (LPM) effect
This is a phenomenon where ultra-high energy particles lose energy slowly when passing through matter. Normally, the quantum duration of bremsstrahlung is longer than scattering times, causing suppression. The paper studies how this suppression changes when subsequent pair production overlaps with the bremsstrahlung process.
Medium-induced photon mass (mγ)
This concept accounts for how the surrounding medium affects photons generated during bremsstrahlung. When considering lower energies, the photon gains a mass due to interactions with the medium, which is crucial for accurately describing its propagation and subsequent pair production.
Overlapping pair production correction ($\delta d\Gamma/dx\gamma$)
This term represents the extra rate of energy loss caused by bremsstrahlung photons immediately undergoing pair production. The paper shows that this overlap disrupts the standard LPM suppression, leading to a higher total bremsstrahlung rate than predicted by the original LPM model alone.

Terminology used across episodes

This episode discusses

The paper

Calculating extremely high energy bremsstrahlung in matter · Read on arXiv

University of Virginia · State Key Laboratory of Nuclear Physics and Technology, Institute of Quantum Matter, South China Normal University, Guangdong Basic Research Center of Excellence for Structure and Fundamental Interactions of Matter, Guangdong Provincial Key Laboratory of Nuclear Science, Guangzhou 510006, China · National Centre for Physics · Theoretical Physics Department at CERN

Transcript

Introduction to the show: ident: High Energy Physics: Phenomenology. The day in particle phenomenology: models, signatures and constraints.

Kai: I'm Kai.

Mira: And I'm Mira, here with Lev.

Kai: We're looking at the paper: "Calculating extremely high energy bremsstrahlung in matter".

Mira: Here's the gist of the paper. Ultra-relativistic electrons initiate electromagnetic showers in ordinary matter that evolve through bremsstrahlung and pair production.

Kai: The paper extends an analysis of the Landau-Pomeranchuk-Migdal (LPM) effect to lower energies by accounting for electron mass and medium-induced photon mass, leading to a rich map of behavior in different regions of (kγ, E).

Mira: Very high energy electrons or positrons passing through ordinary matter lose energy predominantly through showering via repeated bremsstrahlung (e → eγ) and pair production (γ → ee¯) mediated by the electric fields inside atoms.

Kai: At sufficiently high energy, the quantum duration of bremsstrahlung becomes longer than the mean free time between elastic scatterings from the medium, leading to a drastic suppression known as the Landau-Pomeranchuk-Migdal (LPM) effect.

Paper summary: Kai: So to get into this paper "Calculating extremely high energy bremsstrahlung in matter," Peter Arnold and Joshua Bautista are looking at how ultra-relativistic electrons start electromagnetic showers in ordinary matter.

Mira: The central thesis is that as the electron energy gets very high, the quantum mechanical duration of bremsstrahlung starts becoming longer than the mean free time for elastic scattering off particles inside that medium.

Kai: This leads to a significant suppression known as the Landau-Pomeranchuk-Migdal effect in ordinary matter.

Mira: But they found a way to extend this analysis by accounting for the electron mass and also including the photon mass induced by the medium.

Lev: So what does that extension actually claim? It claims that for certain combinations of initial electron energy and photon energy, this overlapping pair production disrupts the standard LPM suppression.

Kai: And when that overlap happens, it means the bremsstrahlung rates are much larger than what you would get from just applying the original LPM rate formula.

Mira: This is important because it shows a correction term is necessary to describe the energy loss in these specific conditions, which leads to a richer map of behavior across different energy regions.

Lev: It suggests that simply ignoring that overlapping pair production effect would lead you to severely underestimate the true bremsstrahlung rates in those regimes.

Kai: This whole paper sets up a framework where they look at how the physics changes when you move from the simple massless case, where m equals zero, to a full treatment including both electron mass and medium-induced photon mass m gamma.

Mira: They use that scale E hat LPM, which is defined as m to the power of four over q hat.

Lev: That scale E hat LPM relates back to the conventional ELPM by a factor of two or one depending on whether you have negligible or extreme suppression.

Conclusion: Kai: So, looking at "Calculating extremely high energy bremsstrahlung in matter," Peter Arnold and Joshua Bautista are essentially showing how the physics gets more complex when you look at very high energies for electron showers.

Mira: It’s about moving beyond the basic Landau-Pomeranchuk-Migdal effect to include things like electron mass and that medium-induced photon mass, which opens up new ways to calculate energy loss rates.

Lev: The implication for a real system is that if you are simulating these high energy losses, ignoring the overlapping pair production correction could lead you to get the wrong picture of how fast particles are actually losing energy.

Kai: The authors show that this correction term can be important enough to make the bremsstrahlung rates significantly larger than predicted by older, simpler LPM calculations in specific conditions.

Mira: It’s about understanding that for a complete picture at these high energies, you need to consider how the dielectric properties of the medium affect both bremsstrahlung and pair production simultaneously.

More episodes

← Home