Search for dark matter axions at 1-2 micro-eV with a RADES-DarkQuantum haloscope at CERN
summary
The gist
The paper describes a proposal to employ CERN’s M1 superconducting magnet to deploy a haloscope to perform a search for galactic axion and axion-like particle dark matter providing continuous…
This episode discusses
- Search for dark matter axions at 1-2 micro-eV with a RADES-DarkQuantum haloscope at CERN · Paper Radio
- Dimensionless constants, cosmology and other dark matters
- Axion dark matter from topological defects
- Axion dark matter in the post-inflationary Peccei-Quinn symmetry breaking scenario
- Gaseous time projection chambers for rare event detection: Results from the T-REX project. II. Dark matter
- Probing the axion-nucleon coupling with the next generation of axion helioscopes
- Experiments to test the hypothesis for solar and dark matter axions
- A Search for Invisible Axion Dark Matter with the Axion Dark Matter Experiment
- A High Resolution Search for Dark-Matter Axions
- The future search for low-frequency axions and new physics with the FLASH resonant cavity experiment at Frascati National Laboratories
- First results of the CAST-RADES haloscope search for axions at 34.67 mu eV
- RADES axion search results with a High-Temperature Superconducting cavity in an 11.7 T magnet
- A proposal for a low-frequency axion search in the 1-2 mu eV range and below with the BabyIAXO magnet
- Thin Film (High Temperature) Superconducting Radiofrequency Cavities for the Search of Axion Dark Matter
- The VORTEX cavity for the RADES axion haloscope
- Search for the Sagittarius Tidal Stream of Axion Dark Matter around 4.55 mu eV
- Axion minicluster streams in the solar neighbourhood
- Characterizing the attenuation of coaxial and rectangular microwave-frequency waveguides at cryogenic temperatures
- The HAYSTAC Axion Search Analysis Procedure
- Challenges and Opportunities of Gravitational Wave Searches at MHz to GHz Frequencies
The paper
Search for dark matter axions at 1-2 micro-eV with a RADES-DarkQuantum haloscope at CERN · Read on arXiv
Alberto Arcusa Puentea, Sergio Arguedas Cuendisl, Marcos Buetas Matac, Sergio Calatronib, Cristian Cogollosd Alejandro D’az-Morcilloe Babette Döobrichd Jacob Eggef, Elisa Gabbrielliid Javier Galindo Guarcha Jose Maráa Garc⸚-Barcel༹og Benito Gimenoh, Yikun Gug Sophia Hollickg Igor Garcia Irastorzag David Kittlingerd Adrian Lambies-Asensioh Axel Lindnerf Manuel Meyeri Adriáan Muónoz-Ur’ane Jose R. Navarro-Madride Tobias Ortmannd Sagar Paulc Angel Rodriguezg Kristof Schmiedenj Laura Seguig Wolfgang Wernsdorferc,k Mina Yamig
Instituto Tecnologico de Arag༹on · CERN - European Organization for Nuclear Research · Karlsruhe Institute of Technology · Max-Planck-Institut fur Physik (Werner-Heisenberg-Institut) · Universidad Politecnica de Cartagena · Deutsches Elektronen-Synchrotron DESY · Centro de Astropart༱culas y Física de Altas Energ༱as (CAPA) Universidad de Zaragoza · IFIC Valencia · CP3-Origins University of Southern Denmark · Rheinische Friedrich-Wilhelms-University · Institute of Quantum Materials and Technologies
Transcript
Introduction to the show: ident: High Energy Physics: Experiment. The day in high-energy experiment: detectors, searches and limits.
Kai: We're looking at the paper: "Search for dark matter axions at 1-2 micro-eV with a RADES-DarkQuantum haloscope at CERN".
Mira: Here's the gist of the paper. The paper describes a proposal to employ CERN’s M1 superconducting magnet to deploy a haloscope to perform a search for galactic axion and axion-like particle dark matter providing continuous coverage from approximately 1.2 to 1.8 µeV Under conservative assumptions, the experiment can reach the QCD axion band over a significant fraction of the scanned range, while optimistic detector performance would allow sensitivity to benchmark models such as KSVZ and DFSZ over a large part of the explored mass interval With the current long shut-down of CERN’s accelerators providing a unique and timely window, such an experiment will deliver high-impact results even in conservative scenarios and potentially delivering a definitive test of the axion dark matter paradigm in the unexplored 1–2 µeV mass range.
Kai: Experimental Setup The proposed RADES-DQLF experiment follows the standard axion haloscope concept described in section 1.
Mira: The cavity resonance is tuned across the target axion-mass range, while the resulting microwave signal is extracted and amplified by a low-noise receiver.
Kai: The experimental design builds on the cavity concepts and technologies developed within RADES and DarkQuantum, adapted to the specific magnetic, cryogenic and mechanical constraints of M1.
Title and authors: Kai: They lay out the experimental setup by following the standard axion haloscope concept, tuning a cavity resonance across the target mass range and extracting that resulting microwave signal with a low-noise receiver <ref:2611.07806#pg1>.
Mira: The design builds on existing cavity concepts from RADES and DarkQuantum, but they had to adapt it to the specific magnetic, cryogenic, and mechanical constraints of the M1 magnet <ref:2611.07806#pg2>.
Lev: They describe the resonant cavities using a quasi-cylindrical geometry based on the RADESBabyIAXO cavity concept, with DQLF-one having dimensions similar to that largest cavity <ref:2611.07806#pg3>.
Kai: They also discuss options for coating the cavity body; they are starting with stainless steel AISI 316L coated with ten microns of electroplated copper, but they have an option to deposit a niobium titanium layer on top of that copper for a ten-fold increase in cavity quality factor Q0 <ref:2611.07806#pg2>.
Mira: The sensitivity relies heavily on the signal-to-noise ratio given by the Dicke radiometer equation, and their receiver chain focuses on a superconducting quantum interference device based first stage amplifier <ref:2611.07806#pg3>.
Lev: They state that microstrip SQUID amplifiers can operate near the quantum limit with noise temperatures as low as five hundred millikelvin at five hundred nineteen megahertz <ref:2611.07806#pg3>.
The paper's summary: Kai: The paper details the integration at CERN’s M1 magnet, which provides a nominal horizontal magnetic field of three tesla at its center <ref:2611.07806#pg2>.
Mira: They outline the data taking protocol, starting with a setup phase, then tuning the cavity resonance, measuring reflection and transmission coefficients to determine cavity parameters Q and beta <ref:2611.07806#pg4>.
Lev: Their sensitivity projections use the standard haloscope signal-to-noise formalism, showing that even under conservative assumptions they expect to probe unexplored parameter space around one point two to two micro-electron volts <ref:2611.07806#pg6>.
Kai: They also mention using three complementary cavity geometries to achieve continuous coverage over the frequency range from approximately two hundred ninety-four to four hundred forty-five megahertz Improvement one <ref:2611.07806#pg1>.
Mira: And they have two acquisition strategies they support: real time spectral averaging and time domain streaming, which lets them adapt to different physics goals and data rates Improvement two <ref:2611.07806#pg1>.
The paper's improvements: Kai: So, the paper wraps up by saying this RADES-DQLF experiment directly addresses a gap in experimental searching for axions in that mass range <ref:2611.07806#pg7>.
Mira: They conclude that deploying three complementary cavity geometries allows for continuous coverage of the targeted mass range, following the same modular strategy used for the full BabyIAXO implementation <ref:2611.07806#pg7>.
Lev: From my side, I see the real value in how they handle calibration and monitoring; they include periodic calibration via a reference tone measurement which triggers a new full calibration when required to ensure stability of the receiver chain Improvement three <ref:2611.07806#pg3>.
Kai: That systematic check is crucial because it maintains the integrity of those sensitivity projections Improvement three <ref:2611.07806#pg3>.
Mira: And they also have an automatic re-coupling procedure that adjusts the port loop angle if coupling deviates from its target value, making sure each frequency point is measured under controlled coupling conditions Improvement four <ref:2611.07806#pg3>.
Lev: That control over coupling is important because accurate sensitivity calculations depend on knowing exactly how well coupled each cavity is Improvement four <ref:2611.07806#pg3>.
Kai: Finally, they monitor the total added noise temperature Tadd and gain Gtotal in real time, where the slope of Pout versus Tload yields the total gain and the intercept provides Tadd Improvement five <ref:2611.07806#pg3>.
Mira: That real time monitoring lets them immediately detect systematic degradations in their setup Improvement five <ref:2611.07806#pg3>.
Lev: And their data treatment follows a pipeline similar to HAYSTAC but uses a library called halolib, which allows for a transparent protocol and lets them use ROOT fitting procedures early on to find bad runs Improvement six <ref:2611.07806#pg3>.
Kai: So, the full picture of this paper is that they’ve designed a robust system using existing technology at CERN M1 to systematically search for QCD axions in the unexplored one point two to two micro-electron volt mass range <ref:2611.07806#pg2>.
Mira: It suggests that with the current shut down of CERN's accelerators, this experiment will deliver high impact results even under conservative assumptions, potentially testing the axion dark matter paradigm in that unexplored range <ref:2611.07806#pg2>.
Lev: The real implication for hardware development is seeing how these sensitivity projections translate when you factor in the actual overhead of running this on real hardware Table three <ref:2611.07806#pg3>.
Kai: Right, so we're done with this paper, but next up we'll look at some work on chromatic calorimetry <ref:2611.07806#pg7>.
Conclusion: Kai: So we've been looking at the RADES-DarkQuantum haloscope at CERN M1 <ref:2611.07806#pg4> and this paper, "Search for dark matter axions at one-two micro-eV with a RADES-DarkQuantum haloscope at CERN," it's about setting up a way to look for those axions, which are these hypothetical particles that could make up dark matter.
Mira: Exactly. The core idea is using the M1 magnet's magnetic field to create these resonant cavities, tuning them across a specific frequency range from two hundred ninety-four megahertz to four hundred forty-five megahertz <ref:2611.07806#pg4>.
Lev: And from an error correction side, the setup means we're dealing with a very large system here, so the sensitivity projections are key because we have to figure out how much noise that real hardware can handle Table three.
Kai: The authors show that even if they use conservative assumptions about detector performance, they still expect to find something interesting in that one point two to two micro-electron volt mass range <ref:2611.07806#pg6>.
Mira: That range is really important because it's where some of the benchmark models, like KSVZ and DFSZ, predict these axions might live <ref:2611.07806#pg3>.
Lev: If we were to run this on real hardware, the overhead of that SQUID-based low noise readout would be a major factor in how fast we could actually sweep through all those frequency points Table three.
Kai: The setup is pretty modular, using three different cavity geometries to get continuous coverage across that mass range, which they call DQLF-one to DQLF-three <ref:2611.07806#pg7>.
Mira: That modular approach lets them systematically search for the QCD axion band while also looking at those benchmark models simultaneously <ref:2611.07806#pg4>.
Lev: And they've included some really good technical details about how they handle coupling deviations automatically, which is something we always worry about when you build hardware that needs to be perfectly tuned Improvement four.
Kai: They also show how they monitor the total added noise temperature and gain in real time so they can catch any systematic issues right away Improvement five.
Mira: So the conclusion is that this experiment fills a gap, giving us a chance to test the dark matter axion idea with high impact results even if things don't turn out perfectly optimistic <ref:2611.07806#pg7>.
Lev: For me, it shows how much experimental control you need when you are trying to get a signal this faint in a cryogenic environment Table three.
Kai: It’s definitely a solid step forward for searching for these particles in that specific mass window <ref:2611.07806#pg2>.
Mira: Next up, we're looking at chromatic calorimetry and how it validates energy resolution in particle detection Background Paper.
More episodes
- Daily Summary for 2026-11-19
- 2512.21290-Model-independent ZH production cross section at FCC-ee
- 2610.21982-First Observation of the Radiative Decay D 0 to gamma omega
- The day in conversation for 2026-11-19
- Daily Summary for 2026-11-19
- Daily Summary for 2026-11-18
- 2512.08065-Searches for Light Dark Matter and Evidence of Coherent Elastic Neutrino-Nucleus Scattering of Solar Neutrinos with the LUX-ZEPLIN (LZ) Experiment
- Daily Summary for 2026-11-18
- 2508.18022-Precision Measurements of the Electroweak Mixing Angle in the Region of the Z pole at the Large Hadron Collider
- 2512.23992-Prospect for measurement of CP-violating parameters of B s 0 to phi gamma at the Tera Z factory