Explicit dispersion relations for elastic waves in extremely deformed soft matter with application to nearly incompressible and auxetic materials

summary

The gist

Explicit dispersion relations for elastic waves in extremely deformed soft matter with application to nearly incompressible and auxetic materials is derived by means of superimposed on large…

In short

The study derives explicit dispersion relations for elastic waves in soft matter under large deformations, specifically focusing on nearly incompressible and auxetic materials. It shows how deformation significantly alters wave speeds based on direction and initial strain, providing tools to design mechanotunable acoustic metamaterials.

Key concepts

Finite Deformations
This describes analyzing material behavior when it is stretched or compressed beyond small, linear limits. The analysis uses a deformation gradient to model the change in shape over time, capturing non-linear effects like chain stiffening or fiber straightening that occur in soft materials.
Auxetic Materials
These are exotic materials characterized by a negative Poisson's ratio, meaning they get thicker when stretched instead of thinner. The paper examines their unique wave propagation behavior, showing how their negative bulk modulus affects pressure and shear wave velocities differently than conventional materials.
Dispersion Relations
These are mathematical equations that relate the frequency of a wave to its wavelength and the material's properties. The paper derives these explicit relations for deformed materials, allowing engineers to predict exactly how waves will travel through these complex structures.
Strain-Energy Density Function (Gent Model)
This is a mathematical model used to describe how energy stored in a material changes when it is deformed. The Gent model specifically accounts for the stiffening effects in polymers or biological tissues, showing that as deformation increases, the material becomes much stiffer.

Terminology used across episodes

This episode discusses

The paper

Explicit dispersion relations for elastic waves in extremely deformed soft matter with application to nearly incompressible and auxetic materials · Read on arXiv

Pavel Galich, Stephan Rudykh

Faculty of Aerospace Engineering, Technion - Israel Institute of Technology

DOI: 10.1016/j.eml.2015.06.003

Transcript

Introduction to the show: ident: Condensed Matter. The day in condensed matter: materials, phases and the measurements under them.

Kai: I'm Kai.

Mira: And I'm Mira, here with Lev.

Kai: We're looking at the paper: "Explicit dispersion relations for elastic waves in extremely deformed soft matter with application to nearly incompressible and auxetic materials".

Mira: Here's the gist of the paper. Explicit dispersion relations for elastic waves in extremely deformed soft matter with application to nearly incompressible and auxetic materials is derived by means of superimposed on large deformations Bloch wave analysis frequently used for investigation of elastic wave propagation The availability of the explicit dispersion relations is important for designing mechanotunable acoustic metamaterials Moreover, the information may greatly benefit non-invasive medical diagnostic techniques by providing the important information on dependence of elastic wave propagation on prestress/pre-strain conditions, which is a common state of biological tissues By application of the derived explicit expressions, we show the role of deformation in wave propagation in soft media undergoing finite deformations Moreover, we extent the analysis to a class of exotic metamaterials characterize by negative Poisson’s ratio (NPR) behaviour Analysis of Material Response The study analyzes the propagation of elastic waves in soft materials subjected to finite deformations.

Kai: For nearly incompressible materials, transverse wave velocities exhibit strong dependence on direction of propagation and initial strain state whereas the longitudinal component is not affected significantly until extreme levels of deformations are attained.

Mira: For highly compressible materials, both pressure and shear wave velocities depend strongly on initial deformation and direction of propagation.

Kai: When compression is applied, longitudinal wave velocity decreases in positive bulk modulus materials, and increases for negative bulk modulus materials; this is regardless the direction of wave prorogation.

Paper summary: Kai: So we started by looking at how wave propagation changes when you subject these soft materials to finite deformations. The core idea here is deriving explicit dispersion relations using superimposed Bloch wave analysis for large deformations <ref:1501.00134#pg1>.

Mira: The paper then applies these derived relations to two key areas: nearly incompressible materials, like biological tissues and polymers, and negative Poisson’s ratio or auxetic materials <ref:1501.00134#pg2>.

Lev: So the main claim is that for these systems, the transverse wave velocities are strongly dependent on direction of propagation and initial strain state <ref:1501.00134#pg3>.

Kai: And for highly compressible materials, both pressure and shear wave velocities depend strongly on both initial deformation and direction of propagation <ref:1501.00134#pg2>. When compression is applied, the longitudinal wave velocity changes depending on the material's bulk modulus <ref:1501.00134#pg2>.

Mira: The methodology involves introducing the deformation gradient F of X and t, and using an approximation of the Arruda-Boyce model, specifically the Gent model for stiffening effects <ref:1501.00134#pg2>.

Lev: The Gent model is used because it neatly covers how polymer chains or collagen fibers get stiffer as deformation increases, and it shows that at a certain level of deformation, the energy function becomes unbounded <ref:1501.00134#pg2>.

Kai: When they look at a finitely deformed neo-Hookean material, they find an acoustic tensor Q of n equals a one n tensor n plus two(I minus n tensor n) with specific definitions for the components a one and a two <ref:1501.00134#pg2>.

Mira: This leads directly to the phase velocities for the pressure wave cpw equals p a one over rho and shear wave velocity csw equals p a two over rho, which simplify to known relations in small deformation limits <ref:1501.00134#pg2>.

Lev: So we see that even when things simplify back to known forms, the underlying structure of the finite deformation still dictates the behavior through those a one and a two terms <ref:1501.00134#pg2>.

Kai: They then show how these relations apply differently depending on whether you're dealing with nearly incompressible or highly compressible materials <ref:1501.00134#pg3>.

Mira: And specifically, for auxetic materials with negative Poisson’s ratio, they observe that the pressure wave velocity increases in any direction of propagation n when the material undergoes compression <ref:1501.00134#pg3>.

Lev: That specific directional effect on the pressure wave is a key result we need to consider if we are building hardware for auxetic phononic crystals <ref:1501.00134#pg3>.

Conclusion: Kai: So wrapping up this paper, the authors derived explicit dispersion relations for finitely deformed materials <ref:1501.00134#pg2>. They showed that deformation has a significant role in wave propagation in both nearly incompressible and extreme auxetic materials <ref:1501.00134#pg2>.

Mira: The implication is that these explicit relations can guide the design of mechanotunable acoustic metamaterials and phononic crystals with a wide range of constituent properties <ref:1501.00134#pg2>.

Lev: So for real hardware, it means we can engineer regions with extreme variations in local phononic properties to create various acoustic effects <ref:1501.00134#pg2>.

Kai: The authors focused on showing that the local distribution of strain field in these engineered materials can induce those extreme variations of local phononic properties <ref:1501.00134#pg2>.

Mira: It's about using the

More episodes

← Home