Performance Analysis of a Dual-Polarised Bowtie Antenna in the Low RF Band: A Low-Cost Undergraduate Laboratory Experiment

summary

The gist

The paper presents an undergraduate laboratory experiment to characterize a dual-polarised bowtie dipole antenna and analyze its performance in the low RF band using polarisation-rotation…

In short

This experiment characterized a dual-polarised bowtie antenna using polarization-rotation measurements in the low RF band (80–320 MHz). The results confirmed that the antenna behaves according to Malus's law, showing high-quality fits and proving both bowtie ports are linearly polarised and orthogonal. The study also analyzed a notch filter's ability to suppress RFI in the Delhi FM band.

Key concepts

Dual-Polarised Bowtie Antenna
This antenna uses two crossed, bowtie-shaped aluminum elements. These elements are oriented orthogonally to each other, which allows the antenna to interact with and respond differently to two independent linear polarizations simultaneously. This design is simple and stable across a wide frequency range.
Polarisation-Rotation Measurement
This method involves physically rotating a receiver antenna while measuring the received signal power at each step. By fitting this data to the Malus equation, researchers can determine the precise angle of the incident source's polarization relative to the antenna's axes.
Cross-Polarisation Discrimination (XPD)
XPD measures how much power is measured in one polarization state compared to an orthogonal state when the source is aligned with the first. Low XPD values indicate significant leakage between the two polarization channels, suggesting minor construction asymmetries in the antenna's arms.
Notch Filter Performance
A notch filter is a band-stop filter designed to significantly attenuate signals within a specific frequency range, such as 80–120 MHz. The study showed this filter effectively suppresses RFI from the Delhi FM band, demonstrating its utility for signal cleaning.

Terminology used across episodes

This episode discusses

The paper

Performance Analysis of a Dual-Polarised Bowtie Antenna in the Low RF Band: A Low-Cost Undergraduate Laboratory Experiment · Read on arXiv

Robin Sen, Akshay Bhatia Neriyanuri, Geetanjali Sethi

Department of Physics, St. Stephen’s College, University of Delhi

We have set up a simple experiment to characterise a dual-polarised bowtie dipole antenna at St. Stephens College as part of undergraduate radio astronomy experiments. The antenna provides two orthogonal linear polarisation responses, allowing us to investigate the polarisation properties of radio-frequency signals using a simple and affordable experimental setup. In this article, we present our analysis of the performance of the antenna and demonstrate its use through polarisation-rotation measurements. This antenna is part of the Sky Watch Array Network (SWAN) and this analysis helps us understand the response of each individual array element in the setup.

Transcript

Introduction to the show: ident: Astrophysics. The day in astrophysics: observations, models and what the data forces.

Vera: We're looking at the paper: "Performance Analysis of a Dual-Polarised Bowtie Antenna in the Low RF Band".

Jocelyn: Here's the gist of the paper. The paper presents an undergraduate laboratory experiment to characterize a dual-polarised bowtie dipole antenna and analyze its performance in the low RF band using polarisation-rotation measurements Performance Analysis of a Dual-Polarised Bowtie Antenna in the Low RF Band: A Low-Cost Undergraduate Laboratory Experiment is an analysis of the performance of a dual-polarised bowtie dipole antenna and demonstrates its use through polarisation-rotation measurements Antenna Design and Characteristics The dual-polarised bowtie antenna is a Murchison Widefield Array (MWA) type antenna with crossed pair of bowtie-shaped elements made of aluminium having a wingspan of 0.74 m and a height of 0.40 m (measured) The vertical bowtie pairs are orthogonal to each other providing dual-linear polarisation The antenna is designed for the 80–320 MHz range.

Vera: Gain and directivity describe the concentration of radiated or received energy in a particular direction, while the radiation pattern describes how this energy is distributed spatially.

Jocelyn: Bowtie antennas offer a simple planar physical structure and stable performance over a wide bandwidth.

Vera: Radiation Pattern Analysis The radiation pattern of an antenna describes the variation of its radiated power with direction and is used to determine how electromagnetic energy is distributed in space.

Paper summary: Vera: This paper, "Performance Analysis of a Dual-Polarised Bowtie Antenna in the Low RF Band: A Low-Cost Undergraduate Laboratory Experiment," essentially presents an analysis of the performance of this dual-polarised bowtie antenna and demonstrates its use through polarisation-rotation measurements.

Jocelyn: The thesis is that by using this simple setup, they can characterize how the antenna responds to different polarisations, which is crucial for understanding how electromagnetic energy gets distributed in space.

Subrahmanyan: What matters here is that it shows the radiation pattern variation with frequency because experimental studies have shown that bowtie antennas generally exhibit broad dipole-like far-field radiation patterns, with changes in beamwidth and gain occurring across the operating frequency range seven fourteen fifteen <ref:2611.15292#pg3,experimental studies have shown that bowtie antennas generally exhibit broad dipole-like>.

Vera: They look at a horizontal cut at a ten degree elevation to see how the main lobes of the two ports cross along different axes for each polarisation. That’s how they map out what the antenna is actually radiating.

Jocelyn: And then they use polarization-rotation measurements, which is their main technique to find out the source angle by fitting the Malus equation to data points once power values are measured for each rotation.

Subrahmanyan: The cross-polarisation discrimination metrics they calculate, like one being ten log ten of P2 gamma over P2 beta, are used to measure how much power leaks between the two polarisation channels when the source polarisation is aligned with one.

Vera: They also discuss a notch filter they used to suppress radio frequency interference in the range of eighty to one hundred twenty MHz because it shows high attenuation there, especially for things like Delhi FM band signals.

Jocelyn: The paper’s findings confirm that the dual-polarised bowtie antenna responds to incident linear polarisation in a manner consistent with the Malus law model, with high quality fits across the tested frequency range.

Subrahmanyan: They find that the recovered source angles average deviate from a zero degree orientation by less than five degrees at all five frequencies, which they say is reasonable given how they manually aligned the transmitting dipole and the bowtie antenna.

Vera: It confirms that each of those two ports is linearly polarised and that those two ports are orthogonal to each other, which is a pretty solid check for this type of structure.

Jocelyn: So, what we’re seeing here is a practical demonstration using an undergraduate lab setup to characterize these kinds of antennas for real radio astronomy work.

Conclusion: Vera: The title of the paper, "Performance Analysis of a Dual-Polarised Bowtie Antenna in the Low RF Band: A Low-Cost Undergraduate Laboratory Experiment," really tells you what this whole thing is about—it’s about testing an antenna’s performance simply and affordably.

Jocelyn: And the authors are Robin Sen, Akshay Bhatia Neriyanuri, and Geetanjali Sethi from St. Stephen's College in Delhi who put this experiment together.

Subrahmanyan: What this means for the bigger picture is that it validates a simple physical structure like a bowtie antenna for use in radio astronomy setups because it works well across its operating frequency range and shows predictable polarisation behaviour.

Vera: It proves that you don't need massive, complex machinery to get these kinds of fundamental polarization characterizations done; this is accessible science.

Jocelyn: And they show the practical application by demonstrating how this antenna can be used within projects like the Sky Watch Array Network, which gives it real-world relevance in observational astronomy.

Subrahmanyan: The main implication is showing that these simple planar structures can be reliable enough for initial characterization before moving to more complex, large-scale array designs where you need high angular resolution.

Vera: It’s about building confidence in the hardware before you try to build the next generation of massive telescope receivers.

More episodes

← Home