Characterisation Methodology for Persistence and Anti-persistence in IR Detectors for the Euclid and SVOM Space Missions

summary

The gist

H2RG and ALFA are the infrared detectors used in the Euclid and SVOM space missions These types of detectors may be affected by persistence and anti-persistence…

In short

This study developed a universal method using differential ramps and filtering to characterize persistence and anti-persistence in infrared detectors like H2RG and ALFA. The approach revealed spatial variations, environmental influences (temperature, fluence), and non-linear effects, providing insights crucial for flight correction strategies for Euclid.

Key concepts

Persistence
Persistence describes how the response of a detector pixel changes after being exposed to light. It involves the simultaneous trapping and release of electrical charges within the pixel structure when light hits it. This effect distorts the measured signal.
Anti-persistence
Anti-persistence is the opposite phenomenon, where charge dynamics in a detector response are inverted compared to persistence. Characterizing this effect is vital because it reveals further complexities in how these detectors behave under different operating conditions.
Savitzky–Golay filtering
This is a smoothing technique used on data signals. It helps reduce noise while preserving the essential features of the signal, such as peaks and trends. It was employed here to improve the signal-to-noise ratio for extracting persistence and anti-persistence parameters.
Spatial Inhomogeneities
These refer to variations in detector performance across different areas of a detector. The study found 'arc-shaped or ring-shaped regions' of high persistence, suggesting manufacturing defects or uneven trap distributions that vary spatially.

Terminology used across episodes

This episode discusses

The paper

Characterisation Methodology for Persistence and Anti-persistence in IR Detectors for the Euclid and SVOM Space Missions · Read on arXiv

Naomie De Araujo, Aurélia Secrouna, Marie Tourneur Silvaina, Eric Kajfasz –a, Eliott Robineaua, Člioune Diopa

Centre de Physique des Particules de Marseille

H2RG and ALFA are the infrared detectors used in the Euclid and SVOM space missions. These types of detectors may be affected by persistence and anti-persistence, phenomena that distort pixel responses after exposure to light due to simultaneous trapping and release of charges within the pixel. These phenomena have shown to cause biases in flux measurements and potentially false detections, among other effects. This article presents a universal methodology for characterising persistence and anti-persistence using differential ramps, Savitzky--Golay filtering, and non-linearity correction. When applied to ground characterisation data, this approach reveals spatial inhomogeneities, environmental dependencies (in particular fluence, flux, temperature and wavelength), and unexpected spectral effects in ALFA. These preliminary results validate the method and pave the way for in-flight correction models capable of meeting the missions' accuracy requirements.

Transcript

Introduction to the show: ident: Astrophysics. The day in astrophysics: observations, models and what the data forces.

Vera: I'm Vera.

Jocelyn: And I'm Jocelyn, here with Subrahmanyan.

Vera: We're looking at the paper: "Characterisation Methodology for Persistence and Anti-persistence in IR Detectors for the Euclid and SVOM Space Missions".

Jocelyn: Here's the gist of the paper. H2RG and ALFA are the infrared detectors used in the Euclid and SVOM space missions These types of detectors may be affected by persistence and anti-persistence, phenomena that distort pixel responses after exposure to light due to simultaneous trapping and release of charges within the pixel This article presents a universal methodology for characterising persistence and anti-persistence using differential ramps, Savitzky–Golay filtering, and non-linearity correction When applied to ground characterisation data, this approach reveals spatial inhomogeneities, environmental dependencies (in particular fluence, flux, temperature and wavelength), and unexpected spectral effects in ALFA The core of the paper is dedicated to the methodology for characterising (anti-)persistence, including data pre-processing, flux measurement, and the extraction of amplitude and current parameters This approach accounts for the diverse properties of the detectors, aiming to effectively decouple their effects from the (anti-)persistence signals in order to isolate and precisely analyse each contribution The approach consists of two major stages: firstly, a preparation of the raw data and secondly the actual extraction of (anti-)persistence parameters Data Pre-processing Steps Several pre-processing steps are applied to the raw data To mitigate the lack of data, as mentioned above, we have chosen to work with superpixels obtained by averaging 64 × 64 pixels Noise is further reduced thanks to an optimised method using reference pixels Dead and hot pixels, identified as outliers, are masked according to characterisation maps established during tests A final pre-treatment step is the conversion of ADU to electrons Signal Smoothing and Parameter Extraction Although the pre-processing significantly improves the quality of the data, the SNR of the ramp flux remains insufficient to reliably extract anti-persistence To improve the SNR, we further apply the Savitzky–Golay filter, which smooths the data while preserving its essential characteristics The resulting differential ramps reveal signatures of persistence, non-linearity, and other phenomena To study anti-persistence with minimal underestimation, a first treatment is necessary: the correction of nonlinearity After the correction, we have to extract the anti-persistence from the signal To derive the anti-persistence current, we use the same method as for persistence by taking the derivative of the resulting subtracted ramp using the Savitzky–Golay filter Observed Spatial and Environmental Dependencies The preliminary results highlight significant spatial inhomogeneities, revealing "arc-shaped or ring-shaped regions of high persistence, probably related to manufacturing defects and non-uniform trap distributions" These inhomogeneities mirror those described in the state-of-the-art literature The persistence amplitude values increase with rising temperature, particularly within the inhomogeneous zone In ALFA, an annular inhomogeneity is observed in the HE band compared to the JE band, which is unexpected since the literature mentions no wavelength dependency of persistence Fluence and Temperature Effects For fluence dependencies, persistence amplitude values are approximately three times higher in the high-persistence zone For both detectors, a linear regime is observed at low fluence, which saturates from 300 ke− The persistence current is consistent with that of the amplitude in both detectors: it increases with prior fluence and temperature, reaching a saturation threshold around 300 ke− Anti-persistence Dynamics The anti-persistence amplitude shows an increasing trend as the flux increases at low fluxes, suggesting a logarithmic or exponential function The graph of current dependencies also shows interesting results, where we observe a linear trend in this parameter as a function of flux The anti-persistence is therefore all the more difficult to extract from the ALFA detector data due to higher order non-linearities and higher reading noise The anti-persistence, although more difficult to extract, has been successfully isolated, exposing its exponential decay behaviour and correlation with non-linearity Future Work In the future, we will first finalize the method by applying non-linearity correction to all data on the H2RG and ALFA detectors Moreover, it would be interesting to redo this study with super-pixels smaller than 64x64, or even per single pixel We will also extend the anti-persistence analysis to flash illumination tests, which promise to better elucidate its dynamics Over the next year, these results will contribute to a physical model integrating all observed dependencies The model will be useful for developing flight correction strategies, ensuring that Euclid and SVOM achieve their scientific objectives with the required accuracy and reliability Acknowledgements The Euclid Consortium acknowledges the European Space Agency and a number of agencies and institutes that have supported the development of Euclid We express our gratitude to our colleagues at the CPPM (Marseille Center for Particle Physics) for their collaboration and constant support throughout this study This study was made possible thanks to CNES (National Center for Space Studies) and IN2P3 (National Institute of Nuclear and Particle Physics), which funded the current PhD thesis work References

1: Euclid Collaboration: Y.

Vera: Mellier, A.

Jocelyn: Abdurro’uf, and J.

Vera: A.

Paper summary: Vera: So we're looking at this paper by Naomie De Araujo and her team titled "Characterisation Methodology for Persistence and Anti-persistence in IR Detectors for the Euclid and SVOM Space Missions". It basically sets up a way to study these persistence and anti-persistence effects that happen in infrared detectors like H2RG and ALFA, which are used on the Euclid mission.

Jocelyn: Right. So, these phenomena distort what we measure after light hits the pixel because charges get trapped and released at the same time. This paper claims they cause biases in flux measurements and could even lead to false detections.

Subrahmanyan: That's a concern for cosmology because if these detector effects aren't understood, it messes with our dark energy and dark matter measurements one <ref:2611.02860#pg1>. The authors are presenting a universal methodology that uses differential ramps, Savitzky–Golay filtering, and non-linearity correction to characterize these effects.

Vera: Exactly. The main point is that when they test this on ground characterization data, they find spatial variations, dependencies on things like fluence, flux, temperature and wavelength in ALFA detectors.

Jocelyn: It sounds like they're showing how these detector quirks aren't just a fixed number; they depend heavily on the environment where you are observing.

Subrahmanyan: That environmental dependency is key because it means we can’t just treat these detectors as simple black boxes in our cosmological models one <ref:2611.02860#pg1>. The paper shows spatial inhomogeneities, like arc-shaped or ring-shaped regions of high persistence, which they think might be related to manufacturing defects or uneven trap distributions.

Vera: They also found that the persistence amplitude values actually increase with rising temperature, especially in those inhomogeneous zones. That's something we need to keep an eye on when planning our observations.

Jocelyn: And for ALFA specifically, they observed an annular inhomogeneity in the HE band compared to the JE band, which was actually unexpected since some literature didn't mention wavelength dependency for persistence one <ref:2611.02860#pg1>. It's a nice finding that shows how detector properties can be more complex than we initially thought.

Subrahmanyan: From a theoretical standpoint, it means our models need to incorporate these spatial and environmental variations when we try to predict the universe’s structure one <ref:2611.02860#pg1>. If the detector response changes based on where you are in space or what the local conditions are, that adds uncertainty to everything.

Vera: They also looked at fluence dependencies and found that persistence amplitude values are about three times higher in those high-persistence zones. And at low fluence, they see a linear regime before it saturates around three hundred ke minus.

Jocelyn: That saturation point sounds important for setting limits on the radiation we expect from space missions like Euclid one <ref:2611.02860#pg1>. It gives us a concrete threshold for how much light we can expect to see.

Paper summary: Subrahmanyan: If the persistence current is consistent with the amplitude, and it increases with prior fluence and temperature, reaching that saturation around three hundred ke minus, then it provides a clearer picture of how these charge trapping mechanisms scale with energy input one. This helps us build more realistic simulations for detector performance.

Vera: Moving to anti-persistence effects, the paper says the amplitude shows an increasing trend as flux increases at low fluxes, suggesting a logarithmic or exponential function. The current dependencies also show a linear trend as a function of flux for that parameter.

Jocelyn: That sounds like something tricky to measure because of those higher order non-linearities and the reading noise in ALFA data, which makes extracting the anti-persistence signal more difficult one <ref:2611.02860#pg1>. It’s harder to isolate that behavior when you have so much noise.

Subrahmanyan: The paper does successfully isolate the anti-persistence behavior, showing its exponential decay and linking it to those non-linearities we discussed earlier one <ref:2611.02860#pg1>. This connection between persistence and anti-persistence is what makes this analysis useful for understanding the underlying physics of the detectors themselves.

Vera: Looking ahead, they plan to finalize their method by applying that non-linearity correction across all data on both H2RG and ALFA detectors. They also think it would be interesting to redo the study with smaller superpixels, maybe even per single pixel.

Jocelyn: And they want to extend the anti-persistence analysis to flash illumination tests because those tests might give us better insight into its dynamics one <ref:2611.02860#pg1>. It seems like they’re building a really comprehensive picture of these detector issues.

Subrahmanyan: If they can integrate all these observed dependencies—the spatial variations, the temperature effects, and the flux relationships—into a physical model, it could be useful for developing flight correction strategies for Euclid and SVOM one <ref:2611.02860#pg1>. That would directly impact the accuracy of the scientific objectives of those missions.

Vera: So, to wrap up this paper by Naomie De Araujo et al., they developed a universal methodology to characterize persistence and anti-persistence in IR detectors using specific mathematical tools. They found that these effects are sensitive to where you are and what the local conditions like temperature or fluence are, revealing spatial structures and environmental dependencies.

Jocelyn: And their conclusion is that isolating anti-persistence is tough due to non-linearities, but they managed to capture its exponential decay and link it back to the persistence behavior. It really validates their approach for understanding these detector quirks in future missions like Euclid one <ref:2611.02860#pg1>.

Subrahmanyan: What this means for us is that we need a more robust way of modeling the instruments themselves before we rely on their data to map the universe one <ref:2611.02860#pg1>. If we can accurately correct for these detector biases, our cosmological constraints will be much tighter.

Conclusion: Vera: So, we've been looking at how these infrared detectors in Euclid and SVOM have these weird persistence and anti-persistence effects that mess up our measurements after light hits them for a while now.

Jocelyn: And this paper is about setting up a real method to figure out what those effects actually are, using differential ramps and filtering to pull out the signal.

Subrahmanyan: The authors, Naomie De Araujo and her team, they’ve done this characterization on ground data for the H2RG and ALFA detectors.

Vera: They found that these effects aren't just random noise; they show real spatial patterns based on where you are in the detector array.

Jocelyn: It also showed how much things like temperature and incoming light, or fluence, actually change the size of those persistence signals.

Subrahmanyan: This means we can’t just use a single correction factor for everything; the correction depends on where you are and what conditions you're in.

Vera: And they managed to separate out the anti-persistence behavior too, which is harder because of all that non-linearity and noise.

Jocelyn: The conclusion is that they’ve built a way to model these detector quirks so we can get more accurate data from the Euclid and SVOM missions.

Subrahmanyan: It’s important because if we don't correct for this, our cosmological models will be based on flawed input from the instruments themselves.

Vera: So, it’s about making sure that when you look at those distant galaxies, you know exactly what the detector is telling you.

Jocelyn: And they're still planning to test this method on smaller pixels and different types of light to see if it holds up under more real-world conditions.

Subrahmanyan: We’ll keep an eye on those future tests because getting a solid physical model here could really help us build better flight correction strategies for the detectors in space.

More episodes

← Home