Looking forward to inelastic DM with electromagnetic form factors at FASER and beam dump experiments

summary

The gist

Inelastic Dark Matter (iDM) coupled to electromagnetic form factors can be effectively constrained by intensity frontier experiments using the displaced single-photon decay signature The work shows…

In short

The study investigates inelastic dark matter (iDM) coupled to electromagnetic form factors using displaced single-photon decay signatures at experiments like FASER. By considering non-minimal iDM content, the sensitivity reaches into the short-lived regime where $ au ext{ is of order } m$, which aligns with regions relevant for thermal freeze-out.

Key concepts

Inelastic Dark Matter (iDM)
This model involves dark matter particles ($\chi_0$ and $\chi_1$) that can scatter or interact in ways that are not purely elastic when coupled to photons. This inelastic nature allows for different decay signatures, such as displaced single-photon decays, which are key to probing these models.
Effective Lagrangian
This is a simplified mathematical description of the dark matter interactions using specific operators (dimension-5 and dimension-6). It outlines how the dark fermions ($\chi_0$ and $\chi_1$) couple to photons, defining their mass splitting ($\Delta$) and the nature of their interactions.
Thermal Freeze-out
This describes a process in the early universe where dark matter particles stop being produced abundantly due to cooling. The paper finds that for the AM/CR iDM scenario, successful thermal freeze-out requires a specific mass splitting ($\Delta \lesssim O(0.5)$) for the correct relic density ($\Omega_0h^2 \simeq 0.1$) to be achieved.
Displaced Decays
This refers to dark matter particles that travel a measurable distance before decaying, rather than decaying immediately at their production point. Observing these displaced decays is a primary experimental signature used by experiments like FASER and beam dumps to constrain the properties of iDM.

Terminology used across episodes

This episode discusses

The paper

Looking forward to inelastic DM with electromagnetic form factors at FASER and beam dump experiments · Read on arXiv

Krzysztof Jod lowski

Institute for Basic Science (IBS)

DOI: 10.1103/PhysRevD.108.115025

Transcript

Introduction to the show: ident: High Energy Physics: Phenomenology. The day in particle phenomenology: models, signatures and constraints.

Kai: We're looking at the paper: "Looking forward to inelastic DM with electromagnetic form factors at FASER and beam dump experiments".

Mira: Here's the gist of the paper. Inelastic Dark Matter (iDM) coupled to electromagnetic form factors can be effectively constrained by intensity frontier experiments using the displaced single-photon decay signature The work shows that by utilizing additional signatures for such models, the sensitivity reach can be increased towards the short-lived regime, γcτ ∼ O(1) m, which can occur in the region of the parameter space relevant to successful thermal freeze-out Model Scenarios and Effective Lagrangian The study considers iDM composed of two dark fermions, χ0 and χ1, coupled to a photon by dimension-5 operators (EDM and MDM) and dimension-6 operators (AM and CR operator) The key property of this scenario is that the DS states have split masses, ∆ ≡ (mχ1 − mχ0)/mχ0 > 0 The interactions are described by an effective Lagrangian which includes terms for EDM and MDM in the first line, and AM and CR operator in the second line This Lagrangian is an adaptation of the EFT framework used to describe fermionic DM with an elastic coupling to a photon Relic Density Constraints The relic densities of AM/CR iDM are obtained by solving the Boltzmann equations that describe the temperature evolution of the comoving yields Yi for i ∈ 0, 1 The dominant process responsible for the successful thermal freeze-out is χ0-χ1 co-annihilation into SM leptons and hadrons The correct relic density, omega0h2 ≃ 0.1, can only be obtained for sufficiently small values of mass splitting, ∆ ≲ O(0.5) Experimental Signatures and Sensitivity The paper discusses experimental signatures of long-lived iDM, including displaced decays, secondary LLP production, and electron scattering in various experiments For primary LLP production at FASER2, the main channel is vector meson decays V → χ0χ1 Secondary LLP production can be efficient in the coherent regime, involving interactions with the entire nucleus The electron scattering signature at FASERν2 and FLArE leads to sensitivities analogous to the case of elastic coupling studied in

37: Results for Different Operators The results show that secondary χ1 production allows covering a part of the short-lived regime of EDM/MDM that is inaccessible by primary production For AM/CR iDM, the displaced χ1 decays allow FASER2 to be competitive with LEP bounds The non-minimal iDM content allows not only for the decays of heavier DS species, but also for upscattering of the lighter one into the heavier one just in front of the decay vessel, which can lead to greater sensitivity than both displaced LLP decays and scattering with electrons In summary, an iDM with electromagnetic form factors leads to greater detection prospects at FASER, MATHUSLA, and SHiP than the elastic coupling case The non-minimal iDM content allows not only for the decays of heavier DS species, but also for upscattering of the lighter one into the heavier one just in front of the decay vessel, which can lead to greater sensitivity than both displaced LLP decays and scattering with electrons The correct relic density region is covered by FASER2 during the high luminosity era of the LHC for MDM iDM The long-lived nature of χ1 in the AM/CR scenario will allow LHC detectors such as FASER2 and MATHUSLA, and beam dumps like SHiP, to set significant exclusion limits that will be complementary to the existing bounds using other terrestrial searches References

Paper summary: Kai: We've seen the setup for this paper, "Looking forward to inelastic DM with electromagnetic form factors at FASER and beam dump experiments," which focuses on constraining inelastic dark matter using displaced single-photon decay signatures.

Mira: The core thesis is that by using extra experimental signatures, we can increase sensitivity towards a short-lived regime where gamma times tau is around one or more, which matches the region relevant for successful thermal freeze-out.

Lev: They model this scenario with two dark fermions, chi zero and chi one, coupled to a photon via dimension five operators for electric and magnetic dipole moments, and dimension six operators for the anapole moment and charge radius.

Kai: The key feature they introduce is that these dark matter states have split masses where delta E equals the difference between their masses divided by the mass of chi zero.

Mira: They describe these interactions using an effective Lagrangian that includes terms for EDM and MDM in the first line, and AM and CR operators in the second line.

Lev: They then solve the Boltzmann equations to get relic densities for these AM/CR dark matter by looking at how the temperature of these yields evolves.

Kai: The dominant process they find responsible for successful thermal freeze-out is a co-annihilation between chi zero and chi one into Standard Model leptons and hadrons.

Mira: They state that the correct relic density, which is about zero point one h squared, can only be obtained if the mass splitting delta E is small, specifically less than or equal to zero point five <ref:2305.16781#pg1>.

Lev: Experimentally, they look at signatures including displaced decays of chi one states and secondary long-lived particle production in various experiments.

Kai: They also discuss electron scattering in setups like FASER nu two and FLArE as another way to probe these models.

Mira: The results show that secondary chi one production helps cover a part of the short-lived regime for EDM and MDM that primary production simply cannot reach on its own.

Lev: For the AM/CR dark matter, they find that displaced chi one decays allow FASER two to be competitive with bounds from LEP experiments.

Conclusion: Kai: So, looking at the title and authors of "Looking forward to inelastic DM with electromagnetic form factors at FASER and beam dump experiments," it seems the paper is pointing toward better detection prospects for these types of dark matter scenarios.

Mira: The implication is that by considering these non-minimal couplings, we gain access to decays of heavier dark matter states and upscattering effects that can give experiments like FASER two a sensitivity edge over other methods.

Lev: The paper suggests that this approach allows us to set significant exclusion limits using detectors like FASER two, MATHUSLA, and beam dumps like SHiP.

Kai: They suggest that these limits will complement existing bounds from other terrestrial searches for dark matter.

Mira: Overall, the work shows that an inelastic dark matter model with electromagnetic form factors has promising detection prospects at these specific setups because of how they explore different experimental signatures.

More episodes

← Home