Modal Parameter Extraction via Propeller-Driven Vibration Testing

summary

The gist

Ground Vibration Testing (GVT) supports aircraft certification but often requires lengthy and costly campaigns Propeller-driven Vibration Testing (PVT) is assessed here as an outputonly alternative…

In short

The study tested a wing spar using propeller-driven vibration testing (PVT) as an alternative to traditional ground vibration testing. They found that while the first two structural modes were very consistent across different test conditions, the third mode showed reduced repeatability due to propeller effects like bending-torsion coupling. PVT is a useful tool for finding low-frequency data but requires better control over propeller excitation for reliable higher-mode identification.

Key concepts

Ground Vibration Testing (GVT)
Traditional testing used to certify aircraft, involving physical ground vibration tests on components like wing spars. This paper compares PVT against GVT, suggesting PVT can provide a useful output-only alternative for operational modal analysis.
Propeller-Driven Vibration Testing (PVT)
A technique where a structure is excited by an electric motor and propeller instead of ground vibration. It is assessed here as an output-only method, similar to taxi or flight testing, to extract structural information from the aircraft.
Modal Assurance Criterion (MAC)
A mathematical measure used to compare the shape similarity between two different modes (vibrational patterns) identified in a structure. A high MAC value indicates that the two modes are very similar, which is crucial for reliable mode identification.

Terminology used across episodes

This episode discusses

The paper

Modal Parameter Extraction via Propeller-Driven Vibration Testing · Read on arXiv

Department of Aerospace Engineering, Universidad Carlos III de Madrid · School of Engineering, University of the West of England

Ground Vibration Testing (GVT) supports aircraft certification but often requires lengthy and costly campaigns. Propeller-driven Vibration Testing (PVT) is assessed here as an output-only alternative, in line with Operational Modal Analysis approaches such as Taxi Vibration Testing and Flight Vibration Testing. A cantilever Aluminium 7075-T6 wing spar is instrumented with seven accelerometers and excited by an outboard electric motor and propeller. Seven runs are carried out: a motor-off baseline, five constant-throttle cases, and a manual up-down throttle sweep. The acquired spectra indicate that the dominant resonances remain observable under propeller excitation, while low-throttle conditions introduce narrowband harmonics that may mask structural peaks; the sweep reduces persistent overlap. Modal parameters are identified for the baseline and sweep cases using the Natural Excitation Technique with the Loewner Framework (NExT-LF). The first two modes remain closely matched (Modal Assurance Criterion (MAC) > 0.99), whereas the third mode shows reduced repeatability (MAC = 0.827) and a larger frequency shift, consistent with propeller-induced bending--torsion coupling and non-ideal sweep control. Overall, PVT provides a viable complement to GVT for extracting low-frequency modal information and motivates pursuing future work on automated throttle scheduling and coupling-aware test planning.

DOI: 10.1115/SSDM2026-183218

Transcript

Introduction to the show: ident: Electrical Engineering. The day in electrical engineering: signals, systems and the hardware that carries them.

Rosa: We're looking at the paper: "Modal Parameter Extraction via Propeller-Driven Vibration Testing".

Dev: Here's the gist of the paper. Ground Vibration Testing (GVT) supports aircraft certification but often requires lengthy and costly campaigns Propeller-driven Vibration Testing (PVT) is assessed here as an outputonly alternative, in line with Operational Modal Analysis approaches such as Taxi Vibration Testing and Flight Vibration Testing The first two modes remain closely matched (Modal Assurance Criterion (MAC) > 0.99), whereas the third mode shows reduced repeatability (MAC = 0.827) and a larger frequency shift, consistent with propellerinduced bending–torsion coupling and non-ideal sweep control Overall, PVT provides a viable complement to GVT for extracting low-frequency modal information and motivates pursuing future work on automated throttle scheduling and coupling-aware test planning.

Rosa: Experimental Setup Details The study utilized a cantilever Aluminium 7075-T6 wing spar instrumented with seven accelerometers and excited by an outboard electric motor and propeller The experimental campaign was structured as follows: an initial test is conducted with the propeller inactive to establish a baseline reference; this is followed by a set of tests performed at increasing throttle settings (and so propeller speed); finally, a continuous voltage sweep is executed.

Dev: The motor-off impulse test (case i), with the propeller stationary (reference, red curve in Fig.

Rosa: 3), is used as a baseline.

Paper summary: Rosa: So to get into the specifics of Modal Parameter Extraction via Propeller-Driven Vibration Testing, we need to remember this study is assessing PVT as an output only alternative instead of just a full GVT campaign one <ref:2601.08123#pg1,Modal Parameter Extraction via Propeller-Driven Vibration Testing>. The thesis here is that you can use propeller excitation for modal analysis in a way that mimics operational tests like taxi or flight testing one <ref:2601.08123#pg1>.

Dev: They set up this cantilever aluminium seven thousand seventy-five-T6 wing spar and instrumented it with seven accelerometers to get the vibration data, and they excited it with an outboard electric motor and propeller one <ref:2601.08123#pg1,cantilever aluminium 7075-T6 wing spar>. They performed seven runs: a motor-off baseline, five constant throttle cases, and a manual up–down throttle sweep one <ref:2601.08123#pg1,a motor-off baseline, five constant throttle cases, and a manual up>.

Taro: The key claim they are making about the experimental setup is that this specific excitation method allows them to observe the dominant resonances even when the propeller is running one <ref:2601.08123#pg1>. They found that low-throttle conditions do introduce narrowband harmonics, which can mask structural peaks, but a sweep helps spread those tonal components out over a wider frequency interval one <ref:2601.08123#pg1>.

Rosa: And for the analysis part, they used NExT-LF to identify the modal parameters for the baseline and sweep cases two <ref:2601.08123#pg1>. They found that two modes stayed very closely matched with a Modal Assurance Criterion value greater than zero point nine nine two, which is excellent agreement <ref:2601.08123#pg1>.

Dev: But they also found issues with the third mode, where repeatability was lower, with a Modal Assurance Criterion value of zero point eight two seven two, and it had a larger frequency shift two <ref:2601.08123#pg1>. This shift they attribute to propeller-induced bending and torsion coupling and non-ideal sweep control two <ref:2601.08123#pg1>.

Taro: So, the mechanism they are focusing on is that the propeller introduces this extra torsional moment, and that's what causes the third mode to behave differently than the first two modes under these specific testing conditions two <ref:2601.08123#pg1>.

Rosa: The overall conclusion they draw from their findings is that PVT provides a viable way to extract low-frequency modal information, which is often difficult to obtain through traditional GVT methods one <ref:2601.08123#pg1>. This leads them toward future work on automated throttle scheduling and coupling-aware test planning one <ref:2601.08123#pg1>.

Dev: So what this means for the world, if anything? It shows that you don't always need a massive, costly ground vibration testing campaign to get a good understanding of how these structures behave structurally two <ref:2601.08123#pg1>.

Conclusion: Rosa: Thinking about the whole paper called Modal Parameter Extraction via Propeller-Driven Vibration Testing and what we just covered, the authors are essentially saying that this test method is a strong tool for operational modal analysis one <ref:2601.08123#pg1,Modal Parameter Extraction via Propeller-Driven Vibration Testing>. It’s an output only alternative to traditional ground vibration testing one <ref:2601.08123#pg1>.

Dev: They’re arguing that by using propeller excitation, you can get the data you need for aircraft certification without needing those lengthy and expensive campaigns one <ref:2601.08123#pg1>. The main implication is that it could lower the barrier for getting reliable structural information faster than before two <ref:2601.08123#pg1>.

Taro: I think what they are highlighting is that improved control over how we excite the system—like automating throttle scheduling or planning tests to anticipate coupling effects—is what will really strengthen this method for finding higher order modes two <ref:2601.08123#pg1>.

Rosa: Exactly. They found that improving excitation control and explicitly considering those propeller-induced bending and torsion coupling are key to making this method more reliable when it comes to identifying those higher order modes one <ref:2601.08123#pg1>.

Dev: So, in simple terms, the authors are saying that if you can get the propeller excitation right, especially by planning your tests to account for how the system couples with the propeller, you get a reliable way to extract structural parameters one <ref:2601.08123#pg1>.

More episodes

← Home