Rotating Magnetocaloric Effect in First-order Phase Transition Material Gd5Si2Ge2
summary
The gist
The rotating magnetocaloric effect (RMCE) induced by self-demagnetization has been investigated in the giant magnetocaloric effect (GMCE) material Gd5Si2Ge2.
In short
This study investigated the rotating magnetocaloric effect (RMCE) in Gd5Si2Ge2, a material with a magnetostructural first-order phase transition. Researchers used direct temperature measurements and magnetometry to characterize this shape-dependent effect. Results show that the peak RMCE in Gd5Si2Ge2 is significantly larger than simulated values for pure Gd, suggesting potential for applications.
Key concepts
- Rotating Magnetocaloric Effect (RMCE)
- This effect occurs when a material's magnetic properties change as the external magnetic field rotates relative to the sample's shape. In this study, it was measured in Gd5Si2Ge2 to see how its response differs based on its physical shape.
- Magnetocaloric Effect (MCE)
- The MCE is a phenomenon where a material absorbs or releases heat when an external magnetic field is applied or removed. The study measured both the conventional MCE and the RMCE to understand how these thermal properties vary with magnetic field orientation and sample shape.
- First-order Phase Transition
- This describes a sudden, abrupt change in the material's internal structure when subjected to certain conditions, like temperature or magnetic field. Gd5Si2Ge2 exhibits this transition, which is crucial because it can lead to large changes in magnetic properties and thermal response.
- Shape Dependence
- The way a material responds to external stimuli, such as the RMCE, can change depending on its physical dimensions and orientation. The researchers compared measurements on the actual sample shape against simulations of a thin plate shape to quantify this effect.
Terminology used across episodes
This episode discusses
- Rotating Magnetocaloric Effect in First-order Phase Transition Material Gd5Si2Ge2 · Paper Radio
- Regeneration tests of a room temperature magnetic refrigerator and heat pump
The paper
Rotating Magnetocaloric Effect in First-order Phase Transition Material Gd5Si2Ge2 · Read on arXiv
Rafael Almeidaa, Rodrigo Kiefeb, Ricardo Moura Costa Pintoa, João Sequeira Amaralb, Kyle Dixon-Andersonc,d, Yaroslav Mudrykc,d, João Pedro Araújoa and João Horta Beloa
IFIMUP – Institute of Physics for Advanced Materials, Nanotechnology and Photonics, Department of Physics and Astronomy, Faculty of Sciences of University of Porto · Physics Department and CICECO – Aveiro Institute of Materials, University of Aveiro · Ames Laboratory of US DOE
DOI: 10.1016/j.jallcom.2026.191872
Transcript
Introduction to the show: ident: Condensed Matter. The day in condensed matter: materials, phases and the measurements under them.
Kai: We're looking at the paper: "Rotating Magnetocaloric Effect in First-order Phase Transition Material Gd5Si2Ge2".
Mira: Here's the gist of the paper. The rotating magnetocaloric effect (RMCE) induced by self-demagnetization has been investigated in the giant magnetocaloric effect (GMCE) material Gd5Si2Ge2.
Kai: This shape-dependent effect had thus far only been reported in pure Gd, marking this as the first analysis of the effect in a sample with a magnetostructural first-order phase transition.
Mira: Characterization Methods The RMCE of Gd5Si2Ge2 is characterized using two complementary approaches: direct measurements of temperature to determine ΔTad and ΔTrotad, and magnetometry to determine the isothermal entropy change on field application (ΔSM).
Kai: Direct measurements were conducted with an applied magnetic field up to 1.0 T, while the magnetometry study was performed up to 2.0 T.
Paper summary: Kai: So, this paper is looking at how you can get this rotating magnetocaloric effect when you have material with a first-order phase transition.
Mira: They are investigating the rotating magnetocaloric effect induced by self-demagnetization in Gd5Si2Ge2.
Kai: The central thesis seems to be that they are exploring this shape-dependent effect in a sample that actually undergoes a magnetostructural first-order phase transition.
Mira: So, what they claim is that this is the first analysis of this specific effect in a sample with such a phase transition happening inside it.
Kai: It's interesting because we usually see these kinds of effects only in pure gadolinium.
Lev: From an engineering standpoint, having a shape-dependent effect is something we need to keep in mind when we start thinking about practical devices.
Mira: And the paper is setting up the investigation to see if this effect scales up when you move away from pure materials like Gd into more complex structures.
Kai: Right, and they are setting up two ways to measure this: direct temperature measurements and magnetometry to find the isothermal entropy change on field application.
Lev: I wonder what kind of challenges those measurements present for actual hardware.
Mira: The direct temperature measurement involves cycling the magnetic field while slowly ramping the heat bath temperature, which is called a continuous or cyclic protocol, and they do thermal resets if there's significant thermal hysteresis in the sample.
Kai: And for magnetometry, they use magnetometry to determine the isothermal entropy change on field application, which is measured up to two point zero Tesla <ref:2601.13239#pg3>.
Lev: That sounds like it could be a lot of data processing for real hardware implementation down the line.
Mira: They did direct temperature measurements with an applied magnetic field up to one point zero Tesla, and the maximum plus delta T adiabatic obtained when applying a one point zero Tesla magnetic field in the low demagnetizing field orientation was four point five zero Kelvin at two hundred sixty-five point five five Kelvin.
Kai: That is a solid number for the maximum adiabatic temperature change they got in that setup.
Mira: Then they look at the rotating magnetocaloric effect results, and they find the peak value of delta T rotating adiabatic measured for one point zero Tesla was one point six six Kelvin at two hundred sixty-seven point seven seven Kelvin.
Lev: one point six six Kelvin is a definite result, but we have to remember that it's only thirty-seven percent of the maximum value they got for the conventional magnetocaloric effect in the low demagnetizing field orientation.
Mira: And they also report the highest delta T rotating adiabatic measured overall was one point seven seven Kelvin, which came from a first zero point eight Tesla field rotation at two hundred sixty-five Kelvin.
Kai: That's a bit of a jump there, from one point six six to one point seven seven Kelvin, but it shows they are looking for the maximum possible effect under rotation.
Mira: And the maximum isothermal entropy change on field application obtained for the low demagnetizing field orientation was negative sixteen point four nine joules per kelvin kilogram and was in good agreement with a previous study that used similar measurement procedures.
Lev: That agreement with previous work is important because it gives us some confidence in the measurement process before we even worry about the geometry of the sample.
Kai: The next part of this paper then moves into indirect magnetometry and simulations to get a better picture of how this happens in three dimensions.
Mira: They determine that delta S on field application from magnetization measurements by numerically integrating the Maxwell relation.
Kai: And they use finite element method magnetostatic simulations, FEMCE, to figure out the three dimensional magnetic field distribution inside the sample shape at each temperature and orientation.
Conclusion: Kai: So, looking at the whole picture of this paper on the Rotating Magnetocaloric Effect in First-order Phase Transition Material Gd5Si2Ge2, it seems like they are focusing on how this effect changes depending on the shape of the sample.
Mira: They found that changing the shape from what they measured experimentally to what their simulations showed for a thin plate decreased delta T adiabatic from zero point one three to zero point zero five and increased delta T transverse adiabatic from zero point six two to zero point eight five.
Lev: That drop in the parallel effect and increase in the perpendicular effect is a pretty clear signature that shape matters a lot here.
Kai: And for this thin plate of gadolinium, the magnetic entropy change was negative eight point six seven joules per kelvin kilogram, which is thirty-five percent more than what they got from the maximum obtained for the experimentally measured shape.
Mira: They also noted that this peak rotating magnetocaloric effect in Gd5Si2Ge2 is over five times bigger than what they got from simulations for gadolinium for both shapes.
Lev: That five times bigger factor is a big piece of information because it suggests the real material has a much stronger response than the simple models predicted.
Kai: The paper also flags a limitation, and they say that in terms of measurement precision, choosing between reasonable variations of the time given for thermal equilibrium after a field change results in a maximum variation of delta T adiabatic below zero point one Kelvin, which is below ten percent for m.
Mira: So the implication here is that when designing magnetic refrigeration systems based on this material, you can't just rely on simple simulations because the real effect is significantly larger and more sensitive to the geometry.
Lev: And for someone building real hardware, that means we need to account for this shape dependence when we design our permanent magnet structures and how we alternate the field.
Kai: The core of this paper is showing that even in a material with a first-order phase transition, you can induce this rotating effect through self-demagnetization by just changing the orientation of the magnetic field.
Mira: It pushes us to think about how material properties change not just with temperature or field strength but also with the physical structure of what we are actually using.
More episodes
- 2610.32678-Probing the limits of materials design via a comprehensive crystal database of 14.6 million structures with 140 properties
- 2610.33595-Native-oxide-driven layer asymmetry, two-step switching and exchange bias in Co/Ir/Co trilayers
- 2503.19572-Spin models from nonlinear cellular automata
- 2606.23350-Irreversibility Enhances Quantum-Enhanced Markov-Chain Monte Carlo
- 2608.02744-Two-Parameter Ansatz for the Violation of Eigenstate Thermalization
- 2210.00806-Low- and high-energy localization landscapes for tight-binding Hamiltonians in two-dimensional lattices
- 2409.09625-Selective switch for band-edge alignments in pentagonal CdSeTe monolayer: Atom-valley locking
- 2606.20168-Norms, overlaps and Yangian descendants for the Haldane-Shastry spin chain
- 2512.19503-Strain-induced splitting of the CCDW-NCCDW phase transition in 1T-TaS 2
- 2307.12638-Strong localization of microwaves beyond two dimensions in aperiodic Vogel spirals